Jump to content
SAU Community

Recommended Posts

hey ALL.

quick question due to expencive fuel price, my car is alway on boost. do i have to do any thing if i turn my boost conrtoler down to say 4psi, another word mostly on vac. its a light modded car with standard ecu.

thanks

depends, is it a stock turbo? the only way to get it to boost so low would be to disconnect the wastegate actuator, and jam the gate fully open. if left connected, it will boost to a minimum of the wastegate actuator spring rate.

Link to comment
https://www.sau.com.au/forums/topic/114308-petrol-price/#findComment-2105738
Share on other sites

r33 s1, stock ecu,stock turbo, 3"inch cat back zost, pod, 11pis boost.the car does move unless i tap it abit harder but then its in boost so i back of. wat i meant to say was. do i have to reset ecu, regap spark plugss or thins like that if i turn boost down really low until petrol price drop a little. i get 400ks with 50-55 litres when i fill up.

Edited by bluer33
Link to comment
https://www.sau.com.au/forums/topic/114308-petrol-price/#findComment-2105799
Share on other sites

400km is pretty good though

umm main things to check are the O2 sensor in the exhaust can cause worse economy..

turn the boost back to std 7psi at least.. actuator will allow this..

try a reset on the ecu, also check it for error codes..

Link to comment
https://www.sau.com.au/forums/topic/114308-petrol-price/#findComment-2105838
Share on other sites

speaking of resetting the ecu, should you reset it when you turn up your boost?

i turned mine up to 10 psi from 4 ..

Im also getting 450kms per tank with 10 psi.. (which seems to be pretty good) ..

Cheers,

-JD

thats what i usedto get at 50km trips each way to and from work..

on 11 psi.. but a fair bit of cruising

currently getting about 13L/100kms with 294rwkw.. so needs a light load tune redone.

Link to comment
https://www.sau.com.au/forums/topic/114308-petrol-price/#findComment-2105858
Share on other sites

Exactly. You get more boost the more you put your foot down. Just keep the revs lower (dont change above 3000rpm), don't warm up the car longer than 30 sec, anticipating red lights, steady and smooth accelerator control etc can all help.

Link to comment
https://www.sau.com.au/forums/topic/114308-petrol-price/#findComment-2105970
Share on other sites

lol i love ... untill the fuel prices go down? WE ARE GOING TO GET KILLED BY FUEL PRICES .... it wont go down it will only go up. I payed 1.40 a litre the other day.. when you pay more for a litre of fuel then you do for a litre of milk you know its absolute bullshit. In the few years i have been driving it has gone up almost 60 cents a litre.

Edited by fEkuaR
Link to comment
https://www.sau.com.au/forums/topic/114308-petrol-price/#findComment-2105992
Share on other sites

paul,

have noticed that the closed loop on the power FC doesn't seem as good as on the std ecu.

when cruising it

A) doesn't bounce the AFR guage as much

B) only seems to do it when slightly accelerating and sits within stoich while holding the throttle in one spot.

C) when holding the throttle in one spot and its not bouncing, increased load on the engine (say a slight hill) it will start working.

not that its running too bad, im at 300km and 1/3 tank left.

Link to comment
https://www.sau.com.au/forums/topic/114308-petrol-price/#findComment-2106473
Share on other sites

paul,

have noticed that the closed loop on the power FC doesn't seem as good as on the std ecu.

when cruising it

A) doesn't bounce the AFR guage as much

B) only seems to do it when slightly accelerating and sits within stoich while holding the throttle in one spot.

C) when holding the throttle in one spot and its not bouncing, increased load on the engine (say a slight hill) it will start working.

not that its running too bad, im at 300km and 1/3 tank left.

i noticed this too!!!! maybe we should tune the ecu lean and then turn off closed loop mode ?

Link to comment
https://www.sau.com.au/forums/topic/114308-petrol-price/#findComment-2106889
Share on other sites

The fuel injection map in the ECU is based on airflow load and RPM.

It has nothing to do with boost pressure

boost affects airflow though...

if you wish to turn boost down, unplug the factory boost solenoid and unplug any other boost controller. that way, it will read about 5psi and will never go into 'high' mode.

Link to comment
https://www.sau.com.au/forums/topic/114308-petrol-price/#findComment-2106982
Share on other sites

whilst you are correct, the throttle pedal decides the final factor.

sure if you run 10psi and full throttle it, its going to chew through lots more air. but thats the throttles fault i would expect (ie: the driver) and not turbocharger boost pressure

Link to comment
https://www.sau.com.au/forums/topic/114308-petrol-price/#findComment-2106996
Share on other sites

I've noticed that the closed loop on the PowerFC is pretty good. Cruising, accelerating lightly, idling etc, my wideband is always reporting a stoich AFR. I guess it comes down to how close your base map is to stoich! (and the condition of the factory O2 sensor)

Edited by Busky2k
Link to comment
https://www.sau.com.au/forums/topic/114308-petrol-price/#findComment-2108612
Share on other sites

closed loop should be bouncing the AFR's from lean to stoich.

i think its like 10 times per minute or something, not just sitting in the stoich area on the guage..

i think the condition affects how responsive the unit is.

Bluer33 - safc would allow you to tune the ECU beter for more economy as the std maps are fairly rich when your giving it to the car..

gaps would only help if they are wrong and not the correct gap.. most people run 0.8 for under 1bar of boost.

dont think a dump would help economy too much, except that it would help with power, so less throttle to do the same as before.. so yes it might, as long as your right foot is in check.

Edited by Craved
Link to comment
https://www.sau.com.au/forums/topic/114308-petrol-price/#findComment-2108663
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Have a vb in honour of the car comming back
    • It was a great, but typical track day, and some VB was ingested at the night time debrief 🤪
    • And so, to round this out, I couldn't be happier to confirm @MBS206 has decided to buy the car. He drove down from sunny QLD with a trailer last week and it is off to its new home today. I'll let Matt confirm on next steps but I understand broadly that the plan is to leave it pretty much as is, and just get some quality wheel time with a nicely balanced car that is pretty much track ready. There are a few a jobs still to be done first but nothing too major and I think its a very smart buy Dinner last night at the Paragon with a round of VBs (mostly) for Neil
    • Well, 50 pages and the end of a chapter for this car. We took it out for a shakedown at Wakie yesterday, and everything went well. There were a couple of niggles: - Oil cooler fitting leak - tightened, cleaned, stopped leaking - Radiator cap overflow fitting was leaking....Mark called it, the overflow fitting was threaded in and not tight....tightened, tested and held pressure - Small oil leak at the rear of the block, probably the turbo oil feed - too hot to get at it comfortably but probably just needs to be nipped up - leak at the driver's side rear brake line where it meets the hardline. Fitting wasn't loose, so Matt backed it off and back on, no further leaks - there's also a leak somewhere on the top of the fuel tank, maybe that cross over fuel line - that was has been left to fix when its on a hoist Otherwise than those niggles the car went great, turned great and stopped great so it was a very successful day out. I'm always really nervous when a car first hits the track after a long break, especially with a brand new engine as well but it was great. VID-20251011-WA0007.mp4  Big thanks to @The Bogan who dropped by and helped out, @MBS206 and my nephew Lachlan the apprentice.  Neil's wife Mel also surprised the hell out of all of us by dropping by; she's up in Tamworth these days but was travelling to Melbourne so had plausible deniability for turning up at the garage, it was great to see her but also obviously a bit sad all round.
    • Skyline R33 Series 2 sedan tail lights in excellent condition. These are becoming harder to find, especially in this state.    BOTH SETS ARE IN FANTASTIC CONDITION (REFER TO PHOTOS)    ✅ No broken covers or cracks ✅ Lenses are in flawless condition ✅ All rear mounting lugs intact ✅ Comes complete as pictured ✅ Perfect for restoration, replacement, or upgrade   These lights are ready to go, no surprises just quality OEM parts.   These are definitely one of the better sets we have seen in a while. With minimal wear and tear they will come as you see. Bear in mind they are not brand new they are almost 30 years old now. To find them in this condition isn’t easy they can only be obtained on the second hand market.   Australia Wide Postage Available At Buyers Expense. Silver Set:$850 Grey Set:$850 PM Me for purchase or any other questions  IMG_2166.dng IMG_2165.dng IMG_2172.dng IMG_2173.dng IMG_2174.dng IMG_2179.dng IMG_2180.dng IMG_2260.dng IMG_2258.dng IMG_2259.dng IMG_2261.dng IMG_2266.dng IMG_2273.dng IMG_2274.dng IMG_2276.dng
×
×
  • Create New...