Jump to content
SAU Community

Recommended Posts

ok i need to know where the engine number is on the block aye cause i can't find it :( mmm if anyone can show me where it is, it would b great...yea pictures will help too...

well my cars a 1995 model Skyline R33 GTS it has the RB25de

Thanks

Cheers

Chi

gearbox is in the middle...

if you look at the front of your car, walk around the passenger side, then stand between the door and the suspension strut, and look at the bottom right of the engine, and the engine number is there somewhere.

should read RB25******

  gazza750 said:
maybe he wants to be sure the engine number and the listed number on the plate match?

No he needs to find it to clean it... refer to his other post in the yellow sticker thread

  Chi100188 said:
man i think i had the same cranky old arse hole aye....he IS NOT NICE AT ALL....haha kelmscott...he looked like he had skin disease aye cranky old mofo....

he got me for windscreen, and he couldn't see my engine number and the back lights aye and suspension....how homo!

Chi

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Then, shorten them by 1cm, drop the car back down and have a visual look (or even better, use a spirit level across the wheel to see if you have less camber than before. You still want something like 1.5 for road use. Alternatively, if you have adjustable rear ride height (I assume you do if you have extreme camber wear), raise the suspension back to standard height until you can get it all aligned properly. Finally, keep in mind that wear on the inside of the tyre can be for incorrect toe, not just camber
    • I know I have to get a wheel alignment but until then I just need to bring the rear tyres in a bit they're wearing to the belt on the inside and brand new on the outside edge. I did shorten the arms a bit but got it wrong now after a few klms the Slip and VDC lights come on. I'd just like to get it to a point where I can drive for another week or two before getting an alignment. I've had to pay a lot of other stuff recently so doing it myself is my only option 
    • You just need a wheel alignment after, so just set them to the same as current and drive to the shop. As there are 2 upper links it may also be worth adding adjustable upper front links at the same time; these reduce bump steer when you move the camber (note that setting those correctly takes a lot longer as you have to recheck the camber at each length of the toe arm, through a range of movement, so you could just ignore that unless the handling becomes unpredictable)
    • I got adjustable after market rear camber arm to replace the stock one's because got sick of having to buy new rear tyres every few months. Can anyone please let me know what the best adjustment length would be. I don't have the old ones anymore to get measurements. I'm guessing the stock measurement minus a few mm would do it. Please any help on replacing them would be fantastic I've watched the YouTube clips but no-one talks about how long to set the camber arm to.
    • Heh. I copied the link to the video direct, instead of the thread I mentioned. But the video is the main value content anyway. Otherwise, yes, in Europe, surely you'd be expected to buy local. Being whichever flavour of Michelin, Continental or Pirelli suits your usage model.
×
×
  • Create New...