Jump to content
SAU Community

R32 Engine Problem

lows_13

By lows_13,
in Engines & Forced Induction

 Share

Recommended Posts

lows_13 Mentor

lows_13

Posted
Posted

Last night i was driving home and all of the sudden when i put my foot down to rev up 3rd gear the engine started to shudder like it was about to run out of gas (the was half a tank of gas in the car). The problem continued for a little bit, i was able to drive home by keeping the rev's under 3000rpm. I rev'd out 2nd gear a few times on the way back home, and everything seemed fine.

Yesterday i took the atmo bov off and connected the standard plumback setup back on, so not sure whether that has anything to do with it.

Also on the odd occasion, when i'm driving i'll put my foot down on the gas and for a split second theres the slightest of hesitation before the engine starts to rev up. Almost like one plug is fouled up.

Any ideas of where to start?

Link to comment
https://www.sau.com.au/forums/topic/118020-r32-engine-problem/
Share on other sites
lows_13 Mentor

lows_13

Posted
  • Author
Posted (edited)

The rubber hose or metal pipe?

I've only run into this problem now that i've put the standard BOV and

plumbing on the car.

What would happen if the standard BOV was to leaking under boost? (would it cause this problem)

Edited by lows_13
R34 VSPEC Enthusiast

R34 VSPEC

Posted
Posted
Last night i was driving home and all of the sudden when i put my foot down to rev up 3rd gear the engine started to shudder like it was about to run out of gas (the was half a tank of gas in the car). The problem continued for a little bit, i was able to drive home by keeping the rev's under 3000rpm. I rev'd out 2nd gear a few times on the way back home, and everything seemed fine.

Yesterday i took the atmo bov off and connected the standard plumback setup back on, so not sure whether that has anything to do with it.

Also on the odd occasion, when i'm driving i'll put my foot down on the gas and for a split second theres the slightest of hesitation before the engine starts to rev up. Almost like one plug is fouled up.

Any ideas of where to start?

Mate, I had similar problems.....the car would be fine during th drive and on the odd occassion, it would shudder and would not respond to the throttle. I've got a multi display screen in car and I can see when this happens, there is no fuel injection at all! Had it checked out and it appeared that the AFM sensor had fouled up due to oil mist build up from the K&N panel filter....at least that's what I've been told...had that cleaned up and problem seem to be gone.

iandawsonwa Contributor

iandawsonwa

Posted
Posted

Yer it would come and go and then some times idle realy low to and sometimes run fine. I also thought it mite have been a miss but when i checked the plugs and coil packs thay all seemed fine. you should change your fuel filter every 60,000 any way

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Marek
      WGNC34 - floor mats

      By Marek · Posted

      Hi 🙋‍♂️. Just bought my Unicorn but the interior need some minor work so it would match my expectations ;). I noticed it is hard to get used oem floor mats in good condition so i started to dig if there's any chance to buy set of new ones. I found two websites - nengun and amayama and it looks like one can still buy factory new floor mats in Japan, but thers a small issue. Some mats (i assume genuine, oem ones) are marked as G4900 and these are "discontinued". The ones you can buy are marked as G4911 but i have no idea if these are also oem, made by other producer or some lower quality replacements that looks entirely different. Can anyone help? 😃  P.s. there is also some strange indication - 0V005, 0V015 and 0V505. Any idea what does it mean? Would appreciate any help with this 🙏
    • Marek
      Hi everyone.

      By Marek · Posted

      Hi, Marek here 🙋‍♂️. I finally fulfilled my longtime dream - recently bought Stagea and now waiting for it to arrive in Poland. There's only few of these in my country, and one of the owners  recommended mi this forum as a source of all the info i'd need since now i own one  so here i am.  
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Version 1 aluminium airbox is.......not acceptable No pics as I "didn't like the look.....alot" Even after all my "CAD", and measurements, the leg near the fusebox just didn't sit right as it ended up about 10mm long and made the angle of the dangle look wrong, the height was a little short as well, meh, I wasn't that confident that Version 1 was going to be an instant winner I might give Version 2 another go, there's plenty of aluminium at work, but, after having in on and off a few times, and laying in the old OEM airbox without the new pod filter and MAF, there may be an option to modify the OEM air box and still use the Autoexe front cover and filter.... maybe This >  Needs to fit in here, but using the panel, and not the pod, the MAF will need to fit in the airbox though> I'm thinking as the old OEM box and Autoexe cover that is sitting in the shed is just sitting around doing nothing, and they are relatively abundant and cheap to replace if I mess it up and need another, it may well fit with some modifications to how the Autoexe brackets mounts to the rad support, and some dremiling to move it get in there, should give me some more room for activities, as I don't want to move the MAF and affect the tune Sealing the hole it requires to stick it in the air box is simple, a tight fit and some pinch weld will seal it up tight  I am calling this a later problem though
    • Dose Pipe Sutututu
      Ethanol Content Sensor - Always at 11%?

      By Dose Pipe Sutututu · Posted

      and it ends up being already priced in as though you're just on 91RON without any ethanol. Car will lose a bit of economy as the short and long term fuel trims bring down the AFR back to stoich or whatever it is for cruise/idle for the engine.  
    • soviet_merlin
      Ethanol Content Sensor - Always at 11%?

      By soviet_merlin · Posted

      Oh, you are right. But, in Australia E10 is based on 91RON fuel and ends up being 94RON. Hence it being the cheaper option for economy cars. The more performance oriented cars go for the 98RON fuel that has no ethanol mixed in. The only step up we have left then at some petrol stations is E85.
×
×
  • Create New...