Jump to content
SAU Community

Recommended Posts

taken from urban dictionary..

"fo shizzle ma nizzle" is a bastardization of "fo' sheezy mah neezy" which is a bastardization of "for sure mah nigga" which is a bastdardization of "I concur with you whole heartedly my African american brother"

bah just rang my accountant - my tax return had been held up for an unknown reason, is now getting priority treatment by the ATO..soooo i guess i can expect it sometime august 2008 :P

bah just rang my accountant - my tax return had been held up for an unknown reason, is now getting priority treatment by the ATO..soooo i guess i can expect it sometime august 2008 :P

I smell tax fraud

Talking about trains reminds me of your misfortune shane and some advice that a certain military corp gave me when there was a rash of AJ bashings. If alone and threatened use some coins in your fist to give a bit more bite to your punch, car keys between the fingers are a good deterent and are hard to disarm, finally your belt acts as a good whip to crack at vunerable areas. ah the old days :dreams:

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
×
×
  • Create New...