Jump to content
SAU Community

Recommended Posts

you see, you must understand young ian, that the world revolves around "pants". without the "pants" you are nothing, and cannot participate in the "great circle of pants" just like in the lion king (but with out elton john) if it has no pants, then it does not exist. there is no meaning to life without "pants".

for when your pants die, and you throw them away. a homeless man finds them, and continues to use them until he gets collected with the trash that he sleeps in. thus dying under the overwhelming smell of garbage and soiled nappies. the pants go with him into the ground, and eventually a "bum tree" is born in its place. from this tree sprout more bums, each with a little bit of those pants, used as a loin cloth.

and so it is that the pants continue this cycle until there is no more to make loin cloths. then the bums discard the loin cloths and mug someone, steeling his pants and the cycle continues.

do you understand now young ian?

just thought i'd increase the random by two notches up to a rating of now 7.23 out of ten :P

no problem :laugh:

:P damn right! i get a box and karen doesnt :wave:

Edited by lilmike86
just thought i'd increase the random by two notches up to a rating of now 7.23 out of ten :happy

:P damn right! i get a box and karen doesnt :wave:

pending the fact that they're still up there ripe for stealing

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...