Jump to content
SAU Community

Recommended Posts

:wave: that mean the manual conversion is complete????

Na the guy comes to inspect the manual parts to make sure they are ok tmr then it will be done asap. I just took another look at the pallet of parts and noticed that the previous owner sent me a starter motor so i thought there may have been a difference

if only i could say that Noel about my soon to be car :(

BYE ANNA!!!! Breakfast???

haha..

hi guys im home now..

come on lee pic me.. and rest of the history.. just incase ur wondering i want to knw about ur car... hehe

:)

quit calling me PRETTY.. haha :wave: <== i really look like that.. :laugh:

haha..

hi guys im home now..

come on lee pic me.. and rest of the history.. just incase ur wondering i want to knw about ur car... hehe

:)

quit calling me PRETTY.. haha :wave: <== i really look like that.. :laugh:

i've told you all i know

dued what else do you want to know?

never been in an accedent ever never broken down since engin swap...

i'm the 1st owner since engin swap and 3 owner since its been imported.....

dude msg me all your other question.... my head hurts from repeating my self so much

:)

dude i'm a very direct person and like to make dections quickly and decicviely using my insticts and gut feelings....

has gotten me in some hairy situations but it always works out in the end

never regreted anything... well except for chatting with Josh :wave:

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
×
×
  • Create New...