Jump to content
SAU Community

Recommended Posts

Shame you cannot come along. We need to get numbers up to this event.

Congrats on the baby though. Do you know what you are having?

I have a 3.5 year old daughter which I spend money on lol.... and my wife expecting in 10 weeks time our second baby :)

We are having a boy, my wife is on leave now sitting at home waiting for the little bastard to come out.

Ahhh i see.

I almost want it....almost

Squizz is never truly gone.

Now I want to see this WRX... Could be tempted to get rid of the Maxima...

Come drive it, I'll cut you a deeeeeeeeeeeeeeeeeeal.

Like "good" herpes.

Wtf is good herpes?

Come drive it, I'll cut you a deeeeeeeeeeeeeeeeeeal.

Like "good" herpes.

No because then when i get a Forester as my daily I will be that full suby guy and will have to buy a blue puffer jacket and shit

Now I want to see this WRX... Could be tempted to get rid of the Maxima...

Wtf is good herpes?

Its bloody great, its an STI from when an STI was still something special and its very tidy.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
×
×
  • Create New...