Jump to content
SAU Community

Recommended Posts

my new turbo arrived today, just thought id share my happiness.

its a schwitzer t88 1100hp rated turbo. apparently been flowed even more than a factory one. this thing is a monster, i cant wait for the lag.. haha

i currently have a gt4088r on it, but its rated at 800hp.

hopefully i can break more than that with my setup..

Link to comment
https://www.sau.com.au/forums/topic/120639-t88-time-ladies/
Share on other sites

  • Replies 54
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

well tuned at 540rwhp, i ran 10.98... could have gone faster, i needed more low down power.. boost dropped off between gears.

with my new setup i should get 9s.... HOPEFULLY

with a powerglide.............. no more manual

Link to comment
https://www.sau.com.au/forums/topic/120639-t88-time-ladies/#findComment-2223813
Share on other sites

danielson: how did you find the GT4088, and what rear did it have on it? at the moment i have the same turbo with 1.34 rear on my RB30DET and it is surprisingly good, considering it's a drag turbo designed for rotaries. in 2nd gear you get full juice at about 4500rpm which i was astounded at.

Link to comment
https://www.sau.com.au/forums/topic/120639-t88-time-ladies/#findComment-2224708
Share on other sites

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...