Jump to content
SAU Community

Recommended Posts

  • Replies 61
  • Created
  • Last Reply

Top Posters In This Topic

I've gotta say, I have no idea where I fit into the family.

Suggestions?

so whos going to volunteer to be the necrophiliac??
Guess you just volunteered? :rofl:

NNNNNNNNnnnnnnnnnnnnnnnnnnnnnnnnoooooooooooooooooooo!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

*scream fades into the distance as if falling off a cliff into a deep ravine* :(:):ermm::D:):dry:

yeah youd have to be used to not getting much of a response.

hey just quietly how much did this thread just disintegrate into depravity? It went from a family with a nice house in the burbs, to the bold and the beautiful, to eminem and his mum, to the MANSON family, to that creepy movie with ewan mcgregor about... well... sleeping with dead people.

i stand by being the hyper friendly morman neighbour.

ps can i borrow some sugar, sugar?

haha "its past bedtime... what do you want? and whats that in your hand..? and WTF are you WEARING?"

youre in for it bro.

*neighbour settles down and takes out his trusty binoculars*

*and camera*

haha "its past bedtime... what do you want? and whats that in your hand..? and WTF are you WEARING?"

youre in for it bro.

*neighbour settles down and takes out his trusty binoculars*

*and camera*

Do you live over the road from me???

haha "its past bedtime... what do you want? and whats that in your hand..? and WTF are you WEARING?"

youre in for it bro.

*neighbour settles down and takes out his trusty binoculars*

*and camera*

:(

GOLD... :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...