Jump to content
SAU Community

Recommended Posts

hi there

i'm looking into getting a TD06 20G 8cm for my cefiro - it has a 2.4 RB20 motor in it. currently have a hks 2530 on the car.

I'm after info with people running the TD06 on a rb25 and also rb20 to see if it is suited for my application... supporting mods are - gtr injectors / z32 afm / power fc / full zorst no mufflers/cat with screamer / fmic / fuel pump / pod / bov etc...

this turbo is also internal gate.

PLEASE HELP!

also if i get a good response i may have a hks 2530 for sale located in SA.

thanks

-Matt

Link to comment
https://www.sau.com.au/forums/topic/126750-td06-20g-8cm-on-rb24/
Share on other sites

run for your life.............

heheh just look for another turbo kit, had trouble with the internal gate, it just doesnt work, you will have to custom fit an external gate and blah blah, basically spend $$$$ to achieve anything. cost me 3k to get it working properly

get a 2535 or go garret unless u like the noisy wastegates

Edited by kidd
i've been speaking to a couple people and some have actually said that it may be more responsive than the 2530?

it feels more responsive than the 2530 on normal driving but it depends on what gear youre on, normally had to drop it into second when a 2530 fitted car would only need third to boost up eg when the traffic lights go amber at 60km/h and we cbf stopping :devil:

If you fit an oil cooler i doubt you'll have problems with the engine temperature (assuming your cooling system is in good nick atm).

I think a TD06 with small rear housing on the rb24 will be a bit of a ball tearer to be honest. Obviously less responsive than a 2530 size turbo but not too far behind and a fair bit more top end. I have seen internal gate td05's perform fine so i don't see how the internal gate 6 will have problems.

If you could get your hands on a used 2535 it could be ok . Or since you have the T3 flanged HKS exhaust housing you could buy a Garrett GT2871R in 48 compressor trim - minus the exhaust housing and fit it in your existing HKS exhaust housing . Assuming your 2530 is a Skyline specific one it has the TO4B compressor cover like Garretts GT2871R series uses so externally it would look the same and use the same water/oil/exhaust plumbing and waste gate actuator . The only difference may be the comp cover inlet boss being 3" or 76mm where the HKS 2530 probably had this bit machined off and an adapter bolted on . You could either get this boss turned down in a lathe or use some kind of step down in the inlet plumbing depending on what you car has .

Just in case you didn't know the 2530 and 2535 and all GT2871R series plus a few others use the same identical turbine and bearing housing so the HKS exhaust housing goes bolt . Done the above mentioned way you wind up with virtually a HKS GT-RS but in 48 comp trim instead of 52 trim (better when boost threshold is an issue eg Cu in starved RB20) and without HKS's custom port shrouded comp cover . The 48 trim compressor is less likely to surge than the 52 trim GT-RS but you could get the 2871R's comp cover drilled and slotted so the port shrouding worked TO4Z style if required .

So if you play your cards right this could be a very cost effective upgrade with what is really a brand newin .

Cheers A .

post-9594-1153454992.jpg

They arent a bad turbo, though as someone else suggested the internal wastegate versions do not seem to enjoy the success of the external gate types. I think thats mostly due to the exhaust housing design and subsequent dump pipe the internal gate version has to run.

Here is an external gate version on a completely std RB20.

Dyno_RacePace.jpeg

well i've made 236 previously with stock rb20 / fmic / zorst / 1.3 bar / hks fcd / stock ecu and injectors...

not going to kill myself if i dont get 240 hehe... just a goal. be happier with insane midrange/lower than peak power atm.

cheers roy and like you said can always change it down the track if i want to :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...