Jump to content
SAU Community

My R33 Gtst F/s Mildly Tuned Street/show Car

SouthernR33
 Share

Recommended Posts

SouthernR33 Enthusiast

SouthernR33

Posted
Posted (edited)

Imported this R33 4 years ago stock as a rock and over the last few years i have built what you see here...

I have never had any problems with this car in the 4 years i have owned it. Serviced regularly and always run on premium fuel. Daily run at .7bar with a high setting of .9 (which i can't remember the last time i used)

Many mods including -

- HKS FMIC

- APEXI power FC - AVCR - RSM - N1 exhaust

- Bosch fuel pump

- Cusco front and rear strut braces

- Turbosmart BOV (plumed back)

- Air pod with shield

- full kit - 400r front - veilside sides and rear - boot lip -

- Carbon fibre bonnet

- 19inch starcorp impuls with near new tyres

- heavy duty single plate clutch

- interior mods

there are more mods i'm sure but interested people will enquire... I built this car with the aim to get decent performance retaining the stock turbo while keeping running costs (fuel) as low as possible. If the intended buyer wanted more power this car is ready for bolt on turbo and injectors to achieve 250+rwkw's however this was not something i desired....

IMO this car is worth a decent sum due to the condition and the reliablility it has shown me over the years. It has never been raced or drifted, it's just not the sort of driver i am....

Anyway the car just clicked over 150xxx k's and i had it serviced recently with the all clear.... Still in amazing condition but within the next 5,000k i feel front pads will need replacing as i just replaced the rears and the rocker cover gasket which was tightened needs replacing as well..

The car is in the southern suburbs of Adelaide for interested buyers.

Enquires welcome on 0433 157 156 or [email protected] price dropped to $17,500

As a side note i may be perswaded to swap this for a smaller non turbo car + cash, which i will require while my home is being built.... (i would love a stockie GTI Proton just to get around in :) )

post-10169-1155802896.jpg

post-10169-1155802955.jpg

post-10169-1155803017.jpg

post-10169-1155803157.jpg

post-10169-1155803275.jpg

Edited by SouthernR33
SouthernR33 Enthusiast

SouthernR33

Posted
  • Author
Posted (edited)

Price drop to $19,500neg...

awesome car, interior is in amazing condition and it runs perfect...

any interest?? This car will be advertised till sold...

i'm happy to negotiate a sale with interested people......

cheers guys

Edited by SouthernR33
SouthernR33 Enthusiast

SouthernR33

Posted
  • Author
Posted (edited)

Another price drop to $18,500 but i'm still negotiable to a certain extent.

This is an awesome car as anyone who has seen it will vouch for.

enquires welcome.

cheers

Edited by SouthernR33
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      S1 rb25/s14 starting problem

      By Duncan · Posted

      Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Waders360
      M35 Brake caliper replacement

      By Waders360 · Posted

      Sorry. Front brake calipers
    • MBS206
      S1 rb25/s14 starting problem

      By MBS206 · Posted

      Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...