Jump to content
SAU Community

Recommended Posts

Hey boyz and girls,

Just wanna get an opinion on types of coolant to use in a GTR. Any particular brands that are good? what ratio mixture should be used?............just want to make sure that coolant types are not detrimental to coolant lines, seals, pumps etc...

Got a mate who recently had coolant changed and was using a 50/50 mixture but car had a syrong coolant smell after the drive................is that normal?

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/128476-which-type-of-coolant-to-use-on-gtr/
Share on other sites

Got a mate who recently had coolant changed and was using a 50/50 mixture but car had a syrong coolant smell after the drive................is that normal?

Cheers.

Smell because while ur mate was filling the radiator up he might spill some on the engine?

Anyway, i think the best is to use NISSAN genunie which available from most Nissan dealer.

redline coolant with inhibitor (pink in colour) with distilled water. good flush out to get rid of the glycol base from previous coolants + rust dirt general crap etc. the stuff works good with glycol, but better without it. or any good quality 50/50 glycol (the green stuff)

i currently have power steering fluid in my raditaor and it hasnt overheaded! (still not reccomending it!)

redline coolant with inhibitor (pink in colour) with distilled water. good flush out to get rid of the glycol base from previous coolants + rust dirt general crap etc. the stuff works good with glycol, but better without it. or any good quality 50/50 glycol (the green stuff)

i currently have power steering fluid in my raditaor and it hasnt overheaded! (still not reccomending it!)

Redline Water wetter is not recommended for winter used, only suitable for summer or track use. If you must use RL WW, pls mix at least 15% coolant and the rest distilled water.

Power steering fluid or ATF in radiator is a major no no. The viscosity of the fluid usually 7cSt or more will decrease the heat transfer rate of the medium (fluid) by hell of alot.

General guide

PSF or ATF ~ -50 to -70% decrease heat transfer

50/50 coolant/water ~ normal heat transfer

RL WW/100% water ~ 50% better heat transfer

i used 2L of genuine coolant from nissan to replace all in my GTR block , radiator and hoses. Make sure u use green coolant. and just use the genuine. if ur too cheap to use a $12.50 per Litre bottle of coolant. then ur prob too cheap to own a Skyline. its gonna be an expensive piece of work.

Redline Water wetter is not recommended for winter used, only suitable for summer or track use. If you must use RL WW, pls mix at least 15% coolant and the rest distilled water.

Power steering fluid or ATF in radiator is a major no no. The viscosity of the fluid usually 7cSt or more will decrease the heat transfer rate of the medium (fluid) by hell of alot.

General guide

PSF or ATF ~ -50 to -70% decrease heat transfer

50/50 coolant/water ~ normal heat transfer

RL WW/100% water ~ 50% better heat transfer

not a good idea to run power steerin fluid in ur coolant true. im not doing it by choice people. NEVER use power steering fluid in ur cooling system

i dont know hows its getting in there but it is. the mechanics trying to figure it out

i used 2L of genuine coolant from nissan to replace all in my GTR block , radiator and hoses. Make sure u use green coolant. and just use the genuine. if ur too cheap to use a $12.50 per Litre bottle of coolant. then ur prob too cheap to own a Skyline. its gonna be an expensive piece of work.

Thanks for all the feedback guys. Just flushed the system and gone 50\50 Geniune Nissan green stuff and demineralised water..............only the best will do!

I checked out the Nissan stuff, I was actually suprised how well priced it was. Very similiar to that of good aftermarket gear.

I'm currently running the Nulon green. I did a little research in to what is required in a good coolant and it had good levels of the good stuff. :P

The nulon green stuff is definitely a good bang for buck coolant.

I prefer Nulon's Concentrate because you know you are getting the right ratio going in. Ie 2.5L for a 7L car.

The problem with premixed stuff is that you'd worry about water left in the block which causes dilution. You'd be suprised how much water stays in the block if you dont drain it out.. like a few litres!

I agree, Nulon's Green Concentrate at 20 bux for 2.5L is by far the best bang for your buck. 5 year protection too. Sweet.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Here's the chart for fuel pressure vs. current draw, assuming your base fuel pressure is 3 bar and you run like 0.5bar boost on WOT, you should only momentarily hit 9amps here and there. (Ignore my prev post, I cannot read a chart these days it seems)
    • Those comp test results are not hideous. Whether they are accurate or not (ie, when that comp tester says 140 psi, is the real pressure120, 140 or 160?) is unknown to us. The state of the battery used to crank it over is unknown, etc etc. Many people around here would say that the absolute values and the spread are perfectly fine to just add boost and keep going. I personally would be happier with a narrower spread than that, but even the diff between 125 and 145 is not terrible. That one cylinder at 125 though, has probably copped some damage relative to the others. You should inspect the valves seeing as you've got it open. Do you know how to measure installed ring gaps? That, and an inspection of the rings themselves, is how you will determine whether they need to be replaced. If you're not good to do these things, take the block and the pistons and rings to a shop that is, and ask them for the go/no-go on them. Do the bores need a hone at all? If so, you might well be justified in getting some different pistons in order to get away from the ring supply problem. Whether you're happy to spend a lot more money right now, on more gear, rather than less money, but an amount that looks stupid given that you will only get a handful of rings in exchange for that money, is for you to decide.
    • also possibly backed up to my filler and shat down it! 🤣
    • Ok so i would love some advice here please, i purchased an R33 a few months back and its had a few mods done to the engine, its an RB25det running a Master ECU, 1200cc injectors, bigger turbo, oil cooler, oil filter relocation kit, Spool H-beam rods, acl/ross pistons. When i removed the motor from the vehicle (as its getting a respray) i thought i would compression test it and these are the following results. Cylinder 1-145psi, Cylinder 2-143psi, Cylinder 3-125psi, Cylinder 4-145psi, Cylinder 5-140psi, Cylinder 6-135psi this test was done with the motor on the ground and powering up the starter motor. I dropped the sump and found broken oil squirters on cylinder 3,5 and 6. I was told my rings are probably worn so i stripped the motor completely to get a new set of rings for it. The trouble is no one has these rings anywhere and they have to be custom made by Ross over in the states and will cost about $600+$200 delivery. My question is how can i tell if my rings are at fault and if they are still ok and is this price ok for a set of rings?
    • What sold me on Trailer Park Boys is this scene: Great stuff, just stay clear from the new Netflix production.
×
×
  • Create New...