Jump to content
SAU Community

Recommended Posts

Hi everyone, these panels have been making wall ornaments in my living room for long enough so they need to go. Rare as hens teeth, i'm not sure if there's any other sets like this in Australia. From other photos i've seen i believe the doors and vented guards are Garage Saurus, the bonnet is Shift Sports (slightly different weave but barely noticeable). Panels aren't perfect but in good condition, bonnet is very good. The main imperfections are in the painted strip at the top of the doors and guards. You could paint it to match your car or very carefully sand it back. These came off my GTR so i know they fit and work exactly the same as stock. Both doors have handles, electrics, window and one will come with some spare hinges and speaker i've got.

Weights (each approx)

Doors 17kg complete with everything (stock ~30kg)

Guards 1.2kg (GTR ~2.5kg, GTST~?)

Bonnet 7kg (GTR ~10kg, GTST ~18kg)

I've had interest from someone wanting the doors only but i'd rather keep such rare panels together so i want to sell the doors and guards together, or the whole set. I'd prefer a local buyer (could probably deliver to Bris/Gold Coast at no cost) but am open to interstate if you've got ideas on how to post carefully.

SOLD.

That's less than 1/3 of the new price! (see here and here)

Lots of pics below and more available by request.

Please PM me or email at [email protected], phone number only to serious buyers.

post-4038-1155561258.jpg

post-4038-1155561310.jpg

post-4038-1155561344.jpg

post-4038-1155561373.jpg

post-4038-1155561411.jpg

post-4038-1155561431.jpg

post-4038-1155561489.jpg

post-4038-1155561519.jpg

post-4038-1155561536.jpg

post-4038-1155561556.jpg

post-4038-1155561582.jpg

post-4038-1155561600.jpg

post-4038-1155561622.jpg

post-4038-1155561644.jpg

post-4038-1155561668.jpg

post-4038-1155561692.jpg

post-4038-1155561713.jpg

post-4038-1155561739.jpg

post-4038-1155561757.jpg

post-4038-1155561785.jpg

post-4038-1155561806.jpg

post-4038-1155561827.jpg

Edited by neil_se

Sorry Stephen, but i'm not willing to go that low at the moment considering how much interest has been expressed in the panels.

Here's some extra pics or the panels fitted to my car (about the only ones i actually took while they were on). The CF looks a bit blotchy in the pics due to being wet when the pic was taken, they're nice and even in real life. The CF would stand out a lot more on a non-grey car, but its still pretty sexy in the flesh.

post-4038-1155640331.jpg

post-4038-1155640349.jpg

post-4038-1155640363.jpg

post-4038-1155640377.jpg

post-4038-1155640387.jpg

Lots of interest but not buyers yet, i'm down in Brisbane and the Gold Coast regularly so i can bring some down for inspections if requested. Don't forget that you can sell of your stock panels for ~$1500 total as well leaving you much less out of pocket :D

  • 2 weeks later...

They're a perfect fit, they came off my GTR and i bolted standard guards straight back in their place.

I've had a bit of interest in the doors and guards separately but i'd prefer to get certain sales on each before i separate. PM me offers for each and i'll consider them in another week if the lot isn't taken together.

cheers

Neil

post-4038-1157170788.jpg

Edited by neil_se
  • 2 weeks later...

Still here, taking offers and available separately. I want money to buy another car so make an offer and you might be suprised (especially Qlders who don't require postage).

Yeah, the paint is a separate layer, it hasn't all been gel coated over or anything. If you run your nail up the guard you can sort of pick your nail on it.

Your 2 options would be to VERY carefully sand back the paint, or an easier option would be to find some sort of paint stripper that won't affect the gel layer over the CF.

Edited by neil_se

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...