Jump to content
SAU Community

Recommended Posts

Sounds more like that it is spinning when it shouldn't. This is because it's a viscous clutch fan, and when it fails, it locks up.

If you start the car when it is dead cold, it should spin up and then come off after a minute.

Or, to test whether it has seized or not, tomorrow morning, open the hood, and try to spin the fan with your hand (car off!). If it resists a LOT, then it's seized and you need to buy a new one. Changing it is pretty easy though (4 bolts), and if you wiggle it, just a little bit, (hehe) it should slide past the radiator shroud.

Sounds more like that it is spinning when it shouldn't. This is because it's a viscous clutch fan, and when it fails, it locks up.

If you start the car when it is dead cold, it should spin up and then come off after a minute.

Or, to test whether it has seized or not, tomorrow morning, open the hood, and try to spin the fan with your hand (car off!). If it resists a LOT, then it's seized and you need to buy a new one. Changing it is pretty easy though (4 bolts), and if you wiggle it, just a little bit, (hehe) it should slide past the radiator shroud.

can it still eb driven until my new fan arrives? and where to get a new one? how much?

Edited by Suspense

You can drive it as much as you like. It will make a lot of noise from the air being pushed, and it will still cool everything (even when it DOESN'T need it).

New fan I think is under $200... Call Nissan?

the clutch on it has FAILED dude. this means what it does next is anybody's guess. which means it may loosen at any moment and start free spinning, i.e. not cool your motor.

if you're going to spend $200 on a clutch fan, why not upgrade to an electric thermofan for a bit more. i'll be doing that mod soon.

Don't panic....... Pull the fan & clutch off, if you're in Sydney, go see the boys at Just Jap in Kirrawee or SSS in Giraween ( or the like ) and grab a good condition second hand clutch off them !! Just make sure it bolts up to YOUR fan and looks the same ( but better than yours ) and away you go !!!

I was a bit suss on my clutch ( fan ) and scored an almost new clutch off an R34 RB25NEO that fit perfectly in my R32 RB20DET fan and works great !!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Reading through the engine service manual their advice is do a cylinder balance test. Unplug one injector at a time and see if the idle drops a consistent RPM. You can also do this using a Consult cable which is easier. They also call for unplugging the power transistor, then with the engine off and the fuel rail unhooked from the manifold verifying that you have good fuel flow (even injection, no dripping/leaks, etc) when you twist the CAS by hand. Also verify the spark by pulling the spark plugs and allowing the plugs to ground and turning the CAS by hand. I would also start doing the sensor checks and idle valve checks in service manual. Make sure the MAF tests reasonably, the intake air regulator is sane, etc. You may have to get new spark plugs.
    • This sounds very old of me, however since buying the Tiguan shit box, my view on shit boxes have changed.
    • I've looked up the parts number (41011AL501). It's around $700 OEM. Usually our Infiniti G35 here in Canada have interchangeable parts with my Stagea but the parts number are not the same. I have looked around and it seems the JDM 2005 V35 Skyline (which is the same as our G35) has the same caliper but I cannot confirm. And I can't find a repair kit. The inner brake pads drags on the rotor, seems to be rusty piston. Thanks for the info by the way
    • This coupled with 6-9 speed autos with ridiculously short gearing is why these modern shitbox cars always seem so fast off the line. If it wasn't for those things, Raptors would not seem fast. The problem we have is there is a driveability gap between a more gentle take off and a wheelspinning sideways launch. The difference between ankle flex required to achieve one and ankle flex required to achieve the other is about 0.5°.
    • Yeah I think I'm also with the opposite here. It's 'hard to keep up with traffic' because in the real world I'm accelerating with 15% throttle and they are pinning it. It feels like I'm being an overt dickhead at anything above 15% throttle, so the car sounds like I'm being an overt dickhead to keep up with/get ahead of traffic when I'm really just trying to drive with traffic. There would be no issue 'keeping up with traffic' if we used the same level of throttle input/aggression to drive around. People really do just drive around with their foot nearly pinned in econoboxes.
×
×
  • Create New...