Jump to content
SAU Community

Recommended Posts

Here is a group buy for 5+ AP engineering Power fc and commanders to suit the R32 GTST (RB20DET) for only $1400 delivered.

These are ready to be shipped as soon as full payment has been made.

Delivery within 5-10 days.

Come with 12 month warranty backed by authorised apexi distributor.

Close date 18/09/06

Payment due - 22/09/06

More types available like D-Jetro or AP units - please PM me for more details.

Boost control kits also available - $420 if purchased with a power fc including delivery.

SEE MY OTHER GROUP BUYS - OVER 200 PFC SOLD TO SAU MEMBERS!!

PFC GB#1

PFC GB#2

PFC GB#3

PFC GB#4

PFC GB#5

PFC GB#6

PFC GB#7

PFC GB#8

PFC GB#9

PFC GB#10

power%20fc.jpg

PFC commander manual - English version

Buyers

1/

2/

3/

4/

5/

(5 buyers is the minimum requirement for the group buy to go ahead)

For those that dont want to wait for the group buy to finish, I have these units available for $1480 delivered.

Cheers :D



  • Similar Content

  • Latest Posts

    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
    • @Duncan I can try  and thanks i did not thought about VIN and part numbers for 33/34. @GTSBoy yeah it looks like iam gonna do that  
×
×
  • Create New...