Jump to content
SAU Community

Big Problem, Need Advice.

SLY33

By SLY33,
in Engines & Forced Induction

 Share

Recommended Posts

SLY33 Mentor

SLY33

Posted
Posted

I really need advice on what could be a crucial decision.

I've suspected for some time now that my wife has been cheating on me. The usual signs...phone rings, but if I answer, the caller hangs up. My wife has been going out with the girls a lot recently, although when I ask their names she always says, "Just some friends from work, you don't know them."

I sometimes stay awake to look out for her cab coming home, but she always comes walking up the drive as I hear the sound of a car leaving, around the corner, as if she has gotten out and walked the rest of the way. Why? Maybe she wasn't in a taxi at all?

I once picked up her cell phone, just to see what time it was. This caused her to go completely berserk. She quickly grabbed the phone out of my hand and cursed me hysterically, screaming that I should never touch her personal property, then accused me of trying to spy on her.

Anyway, I have never broached the subject with my wife. I think deep down I just didn't want to know the truth, but last night she went out again and I decided to really check on her. I decided I was going to park my GTR next to the garage and then hide behind it so I could get a good view of the street around the corner when she came home. It was at that moment, crouching behind my car that I noticed a small amount of motor oil leaking from underneath.

So... is this something I can easily repair myself or do you think I should take it somewhere to get it looked at?

An oldie but a goodie. apologies if its already been posted!

Link to comment
https://www.sau.com.au/forums/topic/136789-big-problem-need-advice/
Share on other sites
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      New kid on the block

      By GTSBoy · Posted

      The wiring diagram for the R33 RB25 is freely available, and is essentially the same same as most other RBs (just with differences as to which pin # does which job). To get the ECU to power up, you just need to provide power to the ECCS relay, and have the other power feeds that come in from the top left of the wiring diagram (wrt the ECU) that give perma power to the fuel pump relay, the ECU itself, etc etc, all connected. When you put power on all these it will just come to life. It's pretty clear from the diagram what needs to happen. Just follow the lines from the 12V + supply stuff in the top left over towards the ECU. I've even posted snips of such diagrams (not for vanilla 25, I think for Neo and 26) to various threads here in the last few months, talking about what it takes to get the fuel pump and FPCM up and going. Search these up and they will help get you started on doing the same with the vanilla 25 diagram. Hell, for all I know, I've done the same with that one in years past and have forgotten.
    • Duncan
      New kid on the block

      By Duncan · Posted

      Yep...so unless someone posts up the answer you will need to probe from the ECU connector to the dash plug with a multi meter in continuity mode to trace the wires.  Note the ECU has multiple - and + (and across different key settings - Battery, IGN and Start) and most likely the power is fed from the connector(s) that is normally near the left hand headlight.
    • Songo
      New kid on the block

      By Songo · Posted

      Thanks Duncan, I am actually just trying to get the Rb turning and running with the RB25DET S2 original loom itself  I am just trying to get it going outside the body and not thinking about the S15 or trying to match anything to the S15 loom at all I am only trying to see if anyone has done this and what pin they found to be the ignition trigger and ECU+/- on the dash connector, that's about it. Thanks  
    • iain_ST44GA
      M35 VQ25DET starter motor

      By iain_ST44GA · Posted

      Hi Guys, Does anyone know any aftermarket part numbers for a starter motor to suit the VQ25DET? I can find lots of alternative part number for the VQ35DE, which I assume would fit, but there is a lot of conflicting information out there. Thanks..
    • Murray_Calavera
      R33 GTR running -9 with no tune

      By Murray_Calavera · Posted

      I don't understand how this hasn't boiled down to - Upgrade the turbo when you have everything required. ECU, injectors, fuel pump, turbo, etc. Do it all at once.  If you don't have everything required, just enjoy the car as it is and keep saving up your pennies. 
×
×
  • Create New...