Jump to content
SAU Community

Recommended Posts

Well,

About this time last year my last car was written off and it was probably for the best because it allowed me to get the car i always wanted.

Well its a 1993 R32 GTST Type-M was in pretty ordinary condition but thats what i wanted, something to work on.

So far theres not too much done too it, and would take on board what ppl think and what else i can do too it

So far:

Engine:

Microtech LT12S - Untuned atm :laugh:

HKS Cam Gears

HKS Fine tune Timing belt

HKS SSQV BOV

Bosch 040

550cc Injectors

Hybrid FMIC

Hybrid electronic Boost controller

Apexi Intake

Highmount T04E Turbo

Full 4" turbo back Exhaust into a Apexi Muffler

Rolling stock:

HSD Coilovers

18" Rims with Nexen 235x18x35 on the front and Nexen 265x18x40 on the rear

Exterior:

Full Final Konnextion Bodykit

Pearl White Respray 14 layers, which changes from green to blue from different angles

Legal Fibreglass vented bonnet

cams%20car.jpg

The dyno sheet below was done after the Highmount turbo was put on everything else was stock, the run was on 12psi and in 3rd gear, I am unsure why they used 3rd i thought they normaly used 4th as its closer to 1:1

cam.jpg

Anyway what do you think, had it for just on a year now

Link to comment
https://www.sau.com.au/forums/topic/138201-my-first-32/
Share on other sites

Well Its ADR apporved, I bought it from DMD Its structualy stronger than the original, and is quite thick. Has a serial number imprinted on it, and a bit of paper from the manafacture stating that this bonnent with serial number ...... meets the requirements of the ....what ever it is.

Havent had any problems from the cops about it

Link to comment
https://www.sau.com.au/forums/topic/138201-my-first-32/#findComment-2575642
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Food for thought, the stock oil filter thread is a 3/4-16 UNF, which has an ID of about 10 to 12mm (according to ChatGPT lol). Now compare than to an 10AN, which has an ID of about 14mm (Raceworks is 14.2mm, Speed flow is 14.27mm).  
    • Yep, totally get that. However hooking in for Generator back up is only a few hundred bucks for the wiring. You could put a couple of those in (for different circuits explicitly) and run a couple of baby generators. Bonus, you can balance them across different circuits, and now have backups in your backup. I'm looking at buying places that won't even have water etc, and I don't mind the idea of getting off the electric grid either, even with everything you've said. This country already has enough power outages that even the mains grid isn't that reliable anymore. I do agree though on spending a bit more to get better gear, and to add some extra redundancy in to the system too.
    • You can set hard reserves on your battery system, and it can't be discharged past that.  
    • That sounds like an excellent idea. But total self-sufficiency means exactly that. You have no-one else to blame when your system faults out and you have no power for a week or two while it gets fixed. You'd have to go the whole hog and get a diesel genny and all the switchover gear, to get you through such times. And, despite the fact that over 20 years, my system has been pretty reliable**, I have seen so many inverter explosions (or less dramatic deaths), panel and roof JB fires, and so on, over that time, to know that the stuff is the same as any other bulk Chinese manufactured stuff. The failure rate is well above zero - both on the equipment and on behalf of the meth addled installation labour force. And then..... warranty and means of redress against the supplier you bought the gear from. Best I can tell is that only a handful of solar companies are still around within 5 years of starting their advertising pitch. They disappear and phoenix like crazy. So, as per 1st paragraph, I suspect the only way to is go balls deep and spend maybe 2-3 times as much as you might think, so that you have every base covered. Plus, know and understand your gear intimately, so you can diagnose problems, sort them out yourself, etc, etc. Plus, probably have to consider upgrading various parts as the years pass, to maintain compatibility with newer stuff, performance and reliability, etc, etc. Whereas, remaining attached to the grid has an ongoing cost that keeps going up even if you use bugger all power from it. But it does provide the fallback in case of the worst case with your own gear. You either pay up front or as you go, I suspect.
    • Add more solar panels to the array. Call the electricity company and tell them you're moving out... Live off grid electric wise
×
×
  • Create New...