Jump to content
SAU Community

Recommended Posts

Brand New Alarm system same function as Viper alarm

R/C Battery Recharge(option)

Super small size(thickness:13.5mm)

Four setps signal sensitivity antenna

Silm 2-Way remote control with LCD (20x24mm) monitor and LED backlight

Using most advance RF combo high stability, long distance, small size

continuously monitor car status

Remote transmitting up to 1000 meters (open field)

Paging transmitting up to 3000 meters (open field)

Five steps of battery level display

LCD clock display

key-press lock function

busy sound indication

vibration and audible warning

arming reminder

silent arming

Panic/car finder

power trunk release

automatic central locking control

shock/lgnition/footbrake/door alarm

alarm report memory

anti-hijacking

auto araming option

power/vacuum type central door lock option

automatic window lifting

remote engine start

remote engine and air-conditioner start

lithium button battery/lithium lon recharge button battery exchange

$290 $250 with delivered

post-32039-1160616399.jpg

Edited by allenlees15
Link to comment
https://www.sau.com.au/forums/topic/138343-fs-alarm/
Share on other sites

  • 3 weeks later...
  • 2 weeks later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • My thought is if you were just moving it forward and the upstream geometry remained the same, then no difference at all. But because the current one has the filter direct into the AFM inlet, you effectively have the best chance of a completely symmetric air flow profile upstream, and in, the AFM, whilst the aftermarket inlet thingo has a (small, to be sure) bend between the filter and the AFM. That would bias the flow to the outside of the bend (downstream of the bend) which might well reduce the size of the signal seen by the AFM, for the same total flow rate. Having said that: If you're proposing to make your inlet look like a hybrid of your existing one and the aftermarket one, such that there is no bend where the filter is clamped on... then I say it will be just fine. If there is going to be such a bend, then, if you can align the insertion of the AFM blade such that it is at right angles to the plane of the bend, then there is a better than even chance that the centreline velocity where the blade is will remain more or less the same, and the velocity will just be a little faster to the outside of that, and just a little slower to the inside. **This is not professional investment advice and you should consult a suitably qualified ouija board, tea leaves or the intestines of a goat for more accurate prognostication.
    • Hi Tao, Thanks for your reply.  It's been a while and I managed to get the valve stem seals replaced with the head on the car.  Unfortunately this didn't solve my issue, the car still smokes a lot after idling (to be honest during idle you can see a bit of blue smoke from the exhaust), same after deceleration. I will try disconnecting the valve cover breathers, do I leave the PCV valve in? By engine oil drain pipe, do you mean the turbo oil drain?
    • What about if you just give it direct 12v and earth?
    • Hi guys . Can someone help me  I bought an Android screen for my Nissan fuga but it won't turn on   
    • My guesstimate, with no real numbers to back it up, is it won't effect it greatly at all.its not a huge change in position, and I can't see the air flow changing from in turbulence that much based on distance, and what's in front of it. Johnny and Brad may have some more numbers to share from experience though.
×
×
  • Create New...