Jump to content
SAU Community

Weather

sammus

By sammus,
in Victoria

 Share

Recommended Posts

sammus Grand Master

sammus

Posted
  • Author
Posted
My car has a protective layer of grime.

hahah yes that's what it was going to be about... how the heat dried the dirt, which turned into fine dirt. and the wind took it like so. but then i decided it was a boring subject. except i pressed post instead of otherwise.

IMG_5754.jpg

Link to comment
https://www.sau.com.au/forums/topic/138381-weather/#findComment-2577275
Share on other sites
sammus Grand Master

sammus

Posted
  • Author
Posted

nah only had car window down while it was idling away.

however, here in my room, all my stuff has a new dirty texture to it having had the window down, even with a flyscreen :teehee:

the cat just walked inside and he's a lighter shade of gray

Link to comment
https://www.sau.com.au/forums/topic/138381-weather/#findComment-2577324
Share on other sites
assyrian4evaa Proficient

assyrian4evaa

Posted
Posted (edited)
Miserable one day...shithouse the next

will soon be replaced permanently with

Beautiful one day - Perfect the next

sif the worlds most liveable city

Melbourne is a hole.

come on man melb isnt that bad i think it is the most livable city in the world :teehee:

Edited by assyrian4evaa
Link to comment
https://www.sau.com.au/forums/topic/138381-weather/#findComment-2577395
Share on other sites
Mavric Grand Master

Mavric

Posted
Posted
Miserable one day...shithouse the next

will soon be replaced permanently with

Beautiful one day - Perfect the next

sif the worlds most liveable city

Melbourne is a hole.

HAHAHA

Geoff you forgot to mention the next part of the QLD weather thats never spoken about where it is hot as all shit and pisses down with rain for a good week :teehee:

Link to comment
https://www.sau.com.au/forums/topic/138381-weather/#findComment-2577622
Share on other sites
inark Grand Master

inark

Posted
Posted
how hot was it today!! then picture me in a mechanic workshop doing a diff in a ba xr6 ute on the freaking floor with dirt and oil all over me!! it reached over 40deg in the workshop.

are u purposely being erotic?

:P

Link to comment
https://www.sau.com.au/forums/topic/138381-weather/#findComment-2578127
Share on other sites
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      S1 rb25/s14 starting problem

      By Duncan · Posted

      Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Waders360
      M35 Brake caliper replacement

      By Waders360 · Posted

      Sorry. Front brake calipers
    • MBS206
      S1 rb25/s14 starting problem

      By MBS206 · Posted

      Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...