Jump to content
SAU Community

Recommended Posts

  • Replies 55
  • Created
  • Last Reply

Top Posters In This Topic

I used to run Mobil 1.

BUT, just as a treat one day and I liked the name I tried Royal Purple, there is no point in trying to sell it. You just have to try it yourself and see the results. I couldn't believe that oil would make such a difference.

Link to comment
https://www.sau.com.au/forums/topic/14-oils-aint-oils/#findComment-232
Share on other sites

  • 3 weeks later...
I used to run Mobil 1.

BUT, just as a treat one day and I liked the name I tried Royal Purple, there is no point in trying to sell it. You just have to try it yourself and see the results. I couldn't believe that oil would make such a difference.[/quote:fd1587d658]

i've heard nothing but praise about the royal purple. it's on everyones top list so it must be worth it. i think i'll try it in around 2000k's when my service is due.

peakRPM, how much do you pay for 5L?

Link to comment
https://www.sau.com.au/forums/topic/14-oils-aint-oils/#findComment-233
Share on other sites

There are about 3 different "grades" of Mobil 1. I'm not talking about the viscosity but the actual quality.

This was news to me a couple of weeks ago. I have been using the 0W40 I get from my Bro in law. Cost price is now $16/litre, used to be around $10. It's good stuff. It's not the same as the stuff you get at K-Mart.

The car blew some tiny puffs of smoke when it 1st went in but now doesn't blow/use any. Thin as water. I change it every 5000 or earlier (usually 'cos I can't quite remember when 5000 is up...)

Recommend it.

Link to comment
https://www.sau.com.au/forums/topic/14-oils-aint-oils/#findComment-234
Share on other sites

In an engine like the RB25DET I think the thinner the better. Nissan engines typically use a fairly thin oil anyway (normally around a 5W I think). Their tolerances seem pretty tight, so the thinner the better especially with the turbo.

In the bike I use a thicker oil (straight 40W or 50W) as it's air cooled and these engines naturally have wider tollerances. If you have an old clunker and it's using/blowing oil try a thicker viscosity.

Whatever you do keep that el Cheapo no name stuff out of your engine. Buy the best you can afford.

Link to comment
https://www.sau.com.au/forums/topic/14-oils-aint-oils/#findComment-238
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
    • My apologies. I forgot we were talking about weird beard M series stuff. Had been talking elsewhere with someone about an R33 with similar subject and got confused.
    • Nope, I don't like the look of ND RF, or any ND really, I don't like their faces or arses, why, because of their "modern" lines, the NC, whilst "modernish" has a more rounded shape that I like Well, that's how my overly judgemental eyes see it anyway  
    • Should be more than fine, especially the overall fuel pressure would never exceed 3.5bar (assuming that thing never gets more than 0.5bar of boost in stock form). According to the chart, it's 11amps.
×
×
  • Create New...