Crank Angle Sensor Help Please

[coryu1]

Hi all,

Im in need of some help, ive bought a crank anle sensor off an rb engine, to be used on a different engine.

Is the gear that goes into the shaft of the sensor able to be detached from the engine?

I found a wiring diagram, http://www.gweeds.net/carpage2/rb25diagram.jpg

But anyone able to tell from the diagram (or your own engine) wether it reads ground, positive, 1 degree, 120 degrees bottom to top, with the latch part of the plug up or down? or can someone take a pic of there plug and wires?

Also is positive is a full 12v?

Thanks heaps

Cory

[blind_elk]

Hi all,

Im in need of some help, ive bought a crank anle sensor off an rb engine, to be used on a different engine.

You mean it's not going onto a RB engine? Or it's from, say, a RB20 and going to, say, a RB25?

Is the gear that goes into the shaft of the sensor able to be detached from the engine?

I don't believe so. I believe the gear and it's associated half-moon key is part of the camshaft.

I found a wiring diagram, http://www.gweeds.net/carpage2/rb25diagram.jpg

But anyone able to tell from the diagram (or your own engine) wether it reads ground, positive, 1 degree, 120 degrees bottom to top, with the latch part of the plug up or down? or can someone take a pic of there plug and wires?

Also is positive is a full 12v?

Thanks heaps

Cory

Can't help you with the rest right now, maybe tonight after I check at home.

[coryu1]

You mean it's not going onto a RB engine? Or it's from, say, a RB20 and going to, say, a RB25?

Yes its going onto a non-rb engine

I don't believe so. I believe the gear and it's associated half-moon key is part of the camshaft.

thanks

Can't help you with the rest right now, maybe tonight after I check at home.

if you could it would be greatly appreciated.

Cory

[blind_elk]

Pin 1 - 120 deg signal

Pin 2 - 1 deg signal

Pin 3 - +12V

Pin 4 - earth

I think that Pin 1 is on the left as you look at the plug with CAS shaft facing down