Jump to content
SAU Community

Recommended Posts

Obviuosly manual.

Anything rwd with decent power. I'm assuming that you don't have a skyline?

No your mum's auto vn commo will not drift well.

Basically, any turbo skyline/silvia/rx7 etc etc will drift ok

na cars can be drifted more and require more skill.

General mods required:

mech diff (a must, once you move from the stock viscous to a mech, you'll notice the diff. When the stock one single wheels, you'll lose control)

suspensions

seat and harness are nice, so you aren't always triyng to brace yourself off the door etc.

stock power is enough to learn on, but air filter, exhaust, highflow cat, fmic won't hurt.

oil cooler depending on how hard you drift (on a 31 degree day, my r33 was starting to get hot, but I drive hard)

camber, castor, swaybars etc.

Link to comment
https://www.sau.com.au/forums/topic/145796-drifting/#findComment-2723431
Share on other sites

RX7's ARE NOT GOOD FOR STARTING TO DRIFT IN.

The only cars you should be looking at are S13 Silvias or maybe DR30/31 Skylines. Someone may be able too drop futher info on those skylines for you compared too the S13.

Link to comment
https://www.sau.com.au/forums/topic/145796-drifting/#findComment-2723451
Share on other sites

anyone watch serious performance 7 i htink.. when the drifter got into the stock auto VT and piled in 4 mates too..... i think it was adam newton if im not mistaken, he did alright, and would have done 100 times better if he had just an LSD

Link to comment
https://www.sau.com.au/forums/topic/145796-drifting/#findComment-2723475
Share on other sites

thanks man naa not yet but yer im lookin for a skyline though im from wa as well where r the drift practice days

check out

www.driftwa.com

or

http://westdrift.com/

you will get all the information you need on where to drift in perth and how much it will cost you :)

AndyMac: it doesnt matter what car you have, althou you think an rx7 will be hard to learn in, other people may fine it quick easy;

Link to comment
https://www.sau.com.au/forums/topic/145796-drifting/#findComment-2723479
Share on other sites

anyone watch serious performance 7 i htink.. when the drifter got into the stock auto VT and piled in 4 mates too..... i think it was adam newton if im not mistaken, he did alright, and would have done 100 times better if he had just an LSD

Anything can be drifted. My last rental vt commo was pretty fun even though it was auto.

like It was said above, it's how well it drifts, and how easy it is to learn.

What's wrong with rx7s?

My friends fd is very easy to drift. Stock, they're pretty neutral in terms of over/understeer.

Link to comment
https://www.sau.com.au/forums/topic/145796-drifting/#findComment-2723484
Share on other sites

' date='3 Dec 2006, 08:22 PM' post='2723479']

check out

www.driftwa.com

or

http://westdrift.com/

you will get all the information you need on where to drift in perth and how much it will cost you :)

AndyMac: it doesnt matter what car you have, althou you think an rx7 will be hard to learn in, other people may fine it quick easy;

thanks man i wil have a look at them

Link to comment
https://www.sau.com.au/forums/topic/145796-drifting/#findComment-2723493
Share on other sites

manual r31 skyline

pull out diff centre, weld it up

has n/a rb30 so enough torque to go for gold. if you get desperate for more power just whack on vl turbo setup. then it'll tyre fry no worries

and some average to half decent shocks money permitting

can even chuck in s13 front arms to go down the s13 coilover route

live axle so its fun to drift with. no hicas or irs dramas

fatz from this forum can prove they are good to go for a cheap weekend fun car ---->

cheers, MARK

Link to comment
https://www.sau.com.au/forums/topic/145796-drifting/#findComment-2723510
Share on other sites

Get an NA car weild the diff....stiffen it to buggery...have a manual and a handbrake that works really well. A corolla with a 4age is fun......a skyline is fun but tends to steer out of a drift cause of the HICAS (remove it and its good). Learning in an underpowered car can teach you to take the right line a speed, can get your confidence up, with a turbo car you can have other problems.

Link to comment
https://www.sau.com.au/forums/topic/145796-drifting/#findComment-2723511
Share on other sites

fatz from this forum can prove they are good to go for a cheap weekend fun car ---->

lol look at all that body roll, im guessin its still got stock suspension..... any more info on that car?

nice to see the vid stopped right before he speared off the track in that first bit of the clip

Link to comment
https://www.sau.com.au/forums/topic/145796-drifting/#findComment-2723577
Share on other sites

lol look at all that body roll, im guessin its still got stock suspension..... any more info on that car?

nice to see the vid stopped right before he speared off the track in that first bit of the clip

That vid was taken when it was a stock standard R31 Silo, prob with a welded diff.....

this is what they did to it :dry:

Link to comment
https://www.sau.com.au/forums/topic/145796-drifting/#findComment-2724100
Share on other sites

  • 3 weeks later...
  • 2 weeks later...

Just wait till it rains and take your shit box auto commy out and learn that way. Thats what i did i got a feel for drift first then started to progress from there. Then when you progress more then mods start comming from what you know you and your car needs to feel right.

Link to comment
https://www.sau.com.au/forums/topic/145796-drifting/#findComment-2784876
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...