Jump to content
SAU Community

Recommended Posts

  • Replies 6k
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

ahh so you think i may need a fuel pump??? i need a few other thing done also so i will check them both out.

i wuold say if you have the money, definately get it done when the PFC is installed.

Hey Sam i'm a Official at Classic Adelaide this year. I registered to be a Course Car, well drive mine as a course car, but unfortunaly i was too late and they have them sorted, so now i'm gonna be in a WRX, which should be a bit of alright!!!! They said Next year as a definate for my car! SAWEEEEET

Hey Sam i'm a Official at Classic Adelaide this year. I registered to be a Course Car, well drive mine as a course car, but unfortunaly i was too late and they have them sorted, so now i'm gonna be in a WRX, which should be a bit of alright!!!! They said Next year as a definate for my car! SAWEEEEET

nice one. it wouldnt be everyday you get given a WRX to drive :P

sup ladies, how are we tonight?

i just dl'd a 50min vid of something along the lines of getaway in stockholm but instead of cars, a go-kart is used. looks pretty good. (darren you might like it since your into carts)

thats all for now......later yoll!!!

Yeh PHAT, nice work on the pick up Duc. The engine on the Kart sounds like it's a 125cc Rotax engine, as they say it can reach upto and over(depending on the single gear used) 160km/h. This is the engine my mate uses for his Superkart(your right there Sam) but can be used in a Sprint Kart. Down the back straight of Mallala my mate has reached high 160's nearly 170km/h, at only 30mm off the ground.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Thanks for that mate always a good help
    • It's not really a calibration issue, if the voltage is really at 2V. If the voltage is 2V, then that's what the TPS is putting out, and the Haltech is seeing that and 2V is about 40% open (you know, between 0.45v being closed and something close to 4.5V being fully open). So, that would suggest that the TPS is maladjusted, on crooked, something something something. Or a wire problem.
    • Hi guys my TPS voltage is reading over 2v at idle.  My Haltech ECU is reading around 40% throttle position at idle also which is really strange. Note the actual throttle position sensor is brand new…    anyone have any experience with this or know how to calibrate it on Haltech ? 
    • The OEM disk will not work on any AEM ECU, you need to use the one they made. You shouldn't have to flip the CAS or whatever you were describing, if you set the ignition sync offset correctly it can't backfire. Make sure you're using a spark plug lead on coil 1 instead of the timing loop to avoid weird issues with the timing light. Double check that your timing settings are actually correct, like is the 24 tooth configured correct or should it actually be 12 teeth for 1 crank revolution? I also found this: 305817248-AEM-Undocumented-Settings-v1-2.pdf    
×
×
  • Create New...