Jump to content
SAU Community

Recommended Posts

I have a late 1995 model skyline, with Series 2 Engine. I have a problem when it gets hot, it basically stalls when I press the accelerator quickly, then release. It also starts to run rich after it has been running for a while, I have changed the ECU, changed the AFM, changed the O2 Sensor, Spark plugs, changed the oil, oil filter, fuel filter... what is involved in keeping these cars running ?.. what decides the fuel mixture, what could be causing this problem ? does anyone know a full list of sensors, and components? if anyone has any idea, just let me know.. I am going to try a few other AFM's, and O2 sensors, to make sure there are a whole pile of faulty ones..

regards

shane

Link to comment
https://www.sau.com.au/forums/topic/15051-car-problems-r33-skyline/
Share on other sites

Shane,

Still racking my brain tryning to think what it is and I still got no idea.... and for the rest of you

Swapped AFM for working one

Swapped ECU

Swapped O2 sensor

Full service

still not fixed??

It won't be cooler piping cause that would be a consistent problem, not 10 minutes after driving, not the BOV cause it would do it when it's cold too...

The problem is after 10-15 minutes of driving the car goes stupidly rich.... when cars warm up the ECU actually runs them leaner (like a choke)....

Hmmmmm..... any one got any ideas cause I'm stumped!

Doc.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The filter only filters down to a specific size. Add to that, the filter is AFTER the pump. So it means everything starts breaking your pump even if its being filtered out.
    • Just like in being 14mm too small (296mm) makes it not fit, being 14mm too big (324mm) it also won't fit. You want to find the correct rotor.
    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
    • I started removing the tank a while back with the intent to give it a proper clean. Got to a bolt that I couldn't undo completely due to a diff being in the way, so just said f**k it and siphoned the gluggy old fuel out and called it a day. Looking it the tank it looks less corroded than the one in the pics for that billet hanger from Frenchy's anyway. Isn't it the fuel filters job to worry about this stuff? I scraped off most the crusty shit of the hanger but will give it another go before reinstall coz maybe the fuel and return pipes are also full of gunk  
    • Pretty sure it is a common fault. I believe this is the only part you need, but don't quote me as I don't have a V36.  I also believe it is a bit of a pain to change and the device needs to be encoded to the car once it is replaced, so may need someone with the right tools. Buy Genuine Nissan 48700JF00D (48700-JF00D) Lock Set-Steering. Prices, fast shipping, photos, weight - Amayama
×
×
  • Create New...