Jump to content
SAU Community

Recommended Posts

Have an rb26 that I am not going to use the block is damaged (cast lugs where mounts go are broken) so I am going to strip it down and sell off.

complete head with cams $1500.00

26 crank $350.00

rods and pistons (stock 26) $350.00

rb26 sump modified for rwd $400.00

rb26 R33 turbos good condition with stock dumps $400.00 pair

rb26 stock manifolds $200.00

nismo twin plate clutch unused push type $1100.00

plenum & t/bs $400.00

have more stuff to add later or just ask I may have what your after.

r33 s2 rb25 turbo suit reco/highflow $350.00

new custom made stainless muffler 3" in 4" dump unused $200.00

r33 ecu $200.00

Edited by rb30dett
Link to comment
https://www.sau.com.au/forums/topic/150880-rb26-go-fast-gear/
Share on other sites

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
    • @Duncan I can try  and thanks i did not thought about VIN and part numbers for 33/34. @GTSBoy yeah it looks like iam gonna do that  
×
×
  • Create New...