Jump to content
SAU Community

Recommended Posts

  • Replies 169
  • Created
  • Last Reply

Top Posters In This Topic

  • 2 weeks later...

i found this post on another site....!!!

Ok peopel that date has been set.

lets make it bigger than the last one

Friday 23rd February. Meet at 8.30pm. Cruise to second lcoation at 10.30pm

the question is, wahts the first meet point gonna be?

I'm happy with Hillarys as its big, under lights and a good palce to shoot for a couple fo hours.

any suggesstions on where to meet before or after then?

What were the police like on the last cruise? Randomly pulling over people for nothing or just the ones that were up to mischief?

The only thing I don't like about big cruises is the unwanted police attention and the amount of idiots it attracts... that and traffic lights argh!

The cruise last time was big and yes some very Stuped ppl but not much cops if I reamber correctly.

And they give you a map all you need to do is mossy on down and have a good time and cruise at your own pase because the cam crews are going to be on random locations on the map thats how it was last time

For this time of year should start somewhere like freo and cruise coastal down to hillarys and if time even on to mindarie

Cops get shitty when you sit in one spot to long cause they know people will get bored and start with the burnouts, so i think three spots will be a better idea and a finish in mindarie would be advisable as cop levels are lower there than hillary's

Will chat to some mates and try to get the cruise some cop leeway, but if you are going to be stupid then they will pull you over......

For this time of year should start somewhere like freo and cruise coastal down to hillarys and if time even on to mindarie

Cops get shitty when you sit in one spot to long cause they know people will get bored and start with the burnouts, so i think three spots will be a better idea and a finish in mindarie would be advisable as cop levels are lower there than hillary's

Will chat to some mates and try to get the cruise some cop leeway, but if you are going to be stupid then they will pull you over......

gret idea so contact person running it to give your ideas to them refer 1st post for his email addy .

he aint reading this forum

  • 2 weeks later...
will there be maps or is it a case of the blind leading the blind? ... even though that happens a lot when there are maps :wave:

not sure about maps, thers going to be AT LEAST 500 cars, so doubt it :S

will someone be kind enough to let me know the second meet location on the night as i will be at work till 11pm:(

sms or contact via mob 0413023655 cheers guys

relaly wanna go but know i will miss the 1030 departure from hiallries

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
×
×
  • Create New...