Jump to content
SAU Community

Recommended Posts

Hi guys,

Just a quick question, noticed that after driving my car, if i pop the bonnet there is always a gurgling sound comming from the engine, sorta sounds like boiling water, not quite that loud, just a slight gurgle.

Is this normal, is there anything i should be concerned about? Car is an r32 GTR.

Cheers,

Dave.

Link to comment
https://www.sau.com.au/forums/topic/152922-gurgling-sound/
Share on other sites

i had a gurgling sound from behind the dash in my old supra and turned out to be the early stages of a blown head gasket...

exhaust gasses were slipping through the head gasket and into the water system causing the gurgling sound

if i were you i'd get it checked out by a radiator shop...

Link to comment
https://www.sau.com.au/forums/topic/152922-gurgling-sound/#findComment-2846165
Share on other sites

I have also experienced this in a camry for about 2 months before my head gasket completly blew. You can check if there is any gasses going into the coolant by running the engine without the radiator cap on and checking to see if any gasses are bubbling out through the coolant. Either that or get your coolant system pressure tested. hope this helps.

Link to comment
https://www.sau.com.au/forums/topic/152922-gurgling-sound/#findComment-2846704
Share on other sites

could just be a simple heating issue... when you turn your car off.. the highest point of collant pressure is then. You might have a slight slpit hose.. or you havent got a completey bled free cooling system.. I would suggest its just the coolant water bubbling away.

Link to comment
https://www.sau.com.au/forums/topic/152922-gurgling-sound/#findComment-2866111
Share on other sites

have a mechanic gas test the radiator, i think it checks for CO-2, but detects exhaust gas in the cooling system.

i had this issue before, and had the test done, it should slightly positive for the gas, so a few months later i changed the head gasket and was all sweet. even though it wasnt over heating.

Link to comment
https://www.sau.com.au/forums/topic/152922-gurgling-sound/#findComment-2871824
Share on other sites

problem is - bubbles popping inside your coolant are basically small explosions = corrosion. Get it checked before it eats away at something. Even if it is something as simple as a unbled coolant system, get it fixed asap

Link to comment
https://www.sau.com.au/forums/topic/152922-gurgling-sound/#findComment-2872455
Share on other sites

I had the same problem in my runabout car. (celica 89) changed my radiator cap and hasn't done it since.

You know the old saying (K.I.S.S.) Keep It Simple Stupid.

You don't want to jump the gun and spend heaps of cash and it ends up being something simple.

hope I helped.

Link to comment
https://www.sau.com.au/forums/topic/152922-gurgling-sound/#findComment-2872474
Share on other sites

mine started making a gurgling noise after i put a new turbo on...

the gurgling noise seems to come from the turbo area.. it happens for a while after the car is turned off. does that sound bad... ?

i dont have any leaking/overheating issues.. everything seems pretty good though.

how do u bleed the coolant.. just undo the cap and let it run for a little while or something ?? oh yeah i use castrol radicool i think it is.. and my radiator cap has one of them buttons in the middle you can press.. if thats good or bad ??

thanks :P

Link to comment
https://www.sau.com.au/forums/topic/152922-gurgling-sound/#findComment-2872655
Share on other sites

mine started making a gurgling noise after i put a new turbo on...

the gurgling noise seems to come from the turbo area.. it happens for a while after the car is turned off. does that sound bad... ?

i dont have any leaking/overheating issues.. everything seems pretty good though.

how do u bleed the coolant.. just undo the cap and let it run for a little while or something ?? oh yeah i use castrol radicool i think it is.. and my radiator cap has one of them buttons in the middle you can press.. if thats good or bad ??

thanks :P

bleed tap on the front of the plenum above your fuel pressure regulator, loosen it off it once its hot since this should be the highest point of the cooling system, once bubbles stop close and it will be bled.

as for turbo, if its high mount it may be acting as the highest point in the system, if there is air in that area once you switch off the car, then this will allow the water to boil in that area.

Link to comment
https://www.sau.com.au/forums/topic/152922-gurgling-sound/#findComment-2872725
Share on other sites

the turbo is a 2535.. is that a high or low mount ??

ill try bleeding her again also, cause i didnt no about the bleed tap thingy :P

bleed tap on the front of the plenum above your fuel pressure regulator, loosen it off it once its hot since this should be the highest point of the cooling system, once bubbles stop close and it will be bled.

as for turbo, if its high mount it may be acting as the highest point in the system, if there is air in that area once you switch off the car, then this will allow the water to boil in that area.

Link to comment
https://www.sau.com.au/forums/topic/152922-gurgling-sound/#findComment-2872792
Share on other sites

My car seems to make a couple gurgling sounds as well, only it isnt while running or after a drive, it is once every morning because of how cold it is starting. it usually takes 2-3 times for the engine to actually start as well. then all day it is perfect. same thing?

Link to comment
https://www.sau.com.au/forums/topic/152922-gurgling-sound/#findComment-2875357
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thanks for doing that Duncan! Makes you a good person in my books. We don't get kangaroos or wombats here. But we have bats and it's similar. AFAIK it's often the mums with a baby attached that get hit because they drop lower when starting from a tree. If you hit an animal, check on it. https://www.ifaw.org/au/resources/wildlife-rescue-app An app to get the closest wildlife rescue contact.
    • My dream is also to have a proper hoist, but I don't think it will ever happen. My quickjack is probably as close as I'll ever get, it really is very good though. 
    • Yeah we keep on in the dailies, it is pretty poor how many animals get hit and the driver leaves without checking....have saved a couple of little ones over the years. Bit of a gruesome job though, pouches generally need to be cut open because they are so tight and often the joey doesn't realise mum is gone so they are still locked onto the teat. I checked the modules in front of the DS wheel where an oil cooler should go.... There is the radar unit - that can go for race use) One of the 2 HX water pumps, the silver cylinder. That needs to be kept but might be able to be relocated But the bad news, the big computer mounted vertically in front of the wheel (blocking any potential air exit) is the electric steering computer. That is required until/unless i do a hydraulic steering conversion, and in CAD based modern car design it is not like I can just pop a big unit like that somewhere else (plus the loom would be too short anywhere else too). So, the passenger side is OK to clear out (just use a smaller washer reservoir, potentially elsewhere), but the DS no beuno
    • Well, all the best with the new camry It was interesting to hear about the UK process, it is generally a lot more streamlined here with a shipping agent looking after all the import side (noting the exact final price can still be a surprise.....) and I've used a few different brokers on the japan (or US) side, and never had any trouble with any of them....luck of the draw I guess. You mentioned you didn't get the auction sheet (understandable since you bought it from a dealer, not auction), but I always try and get hold of that because they are pretty thorough. I've imported 2x R grade vehicles over the years and both were fine, repairs in Japan are pretty thorough compared to here in Oz.
    • BTW I measured the jack I have, it is 70mm at the saddle but you only have about 700 until it returns to 150mm high at the cylinder so it is good but no magic bullet.
×
×
  • Create New...