Jump to content
SAU Community

Dash Display Systems

justinfox

By justinfox,
in Motorsport Discussion & Builds

 Share

Recommended Posts

Roy Grand Master

Roy

Posted
Posted

The PI Dash is pretty much an industry standard. If you can afford it they are great. Though unless you are really going to load your car up with all the sensors it can run (just like a Motec ADL) then there isnt much sense in going for that sort of dash.

I run an AiM dash and very happy with it. The Race Analysis software keep you occupied for a few nights after an event workign out where you can go faster and perhaps where you can tweak the car more.

Stack are very good as well, but the multine line display at the bottom makes it hard to read the channels when you are scrolling through them. The ADL, PI, AiM units are much easier to read when on the run with regards to being a functional dashboard/gauge set.

I use mine primarily as a tacho and 4 analogue gauges with warning and also as a data logger. With the Stack i dont think you get the same versatility

Interior.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • PranK
      Blue slip

      By PranK · Posted

    • GTSBoy
      Ethanol Content Sensor - Always at 11%?

      By GTSBoy · Posted

      But seriously, can we ask for the results of the "tip a bottle of metho into a nearly empty tank" experiment?
    • GTSBoy
      Blue slip

      By GTSBoy · Posted

      Hang on. Let me get this straight. The desire is to have coilovers, BC in particular, to be MORE comfortable on Sydney roads than stock suspension? Well, that's obviously not right. BCs have crude damping design at the very best, and typically hard spring rates. BC stands for Billy Cart. And then, the desire is to put in some shitty old worn out stockers, to get it blue slipped and then put the BCs back in? And then.....what? Not worry about getting pulled up by the Plod? Because you seem to have raised a worry about paying for engineering (which actually does solve all your legality problems) and still getting pulled up.... but the only problem there is that if/when that happens you have to show your paperwork at the inspection station. Whereas, if you just swap in borrowed shitty old stockers to get it slipped now, and then you get defected in the future, you have to go find more shitty old stockers then too. You course of action looks like this set of options: Buy brand new stock type dampers, and springs. probably cost a bit more than $1k all up, but will last for the remaining life of the car. Put them in, pass inspection, drive on them forever more. Hell, they could even be really nice Bilsteins and Kings or other lower&stiffer springs if you wanted. Get the car engineered as is. ~$1k. Buy new Shockworks coilvers (or MCA) and also pay for engineering. You're spending a lot more here. But these will be the best things that you could drive around on.
    • Dose Pipe Sutututu
      Blue slip

      By Dose Pipe Sutututu · Posted

      Might be worthwhile hitting up Facebook's groups, I know most of them contain terrible people and scammers - however you might be able to find someone that's in Sydney with factory suspension you could purchase and/or hire. Just do not send any form of money anywhere, in person cash only.
    • Stringycheese
      Blue slip

      By Stringycheese · Posted

      Thanks @Duncan Ride height is fine. I think it's almost stock tbh. Happy to share a pic. I don't actually have a regular mechanic as haven't lived in Sydney too long. Could you or anyone recommend any shops in Sydney?
×
×
  • Create New...