Jump to content
SAU Community

Got Lucky Hooning

forsalestickers

By forsalestickers,
in Victoria

 Share

Recommended Posts

forsalestickers Rookie

forsalestickers

Posted
Posted

I was with my bro who's 24. He was on the freeway and off the freeway span his wheels a bit because it was wet. A few KM's down the road we get pulled over by a cop who had been following us since the free way. The cop clocked us at 122 and saw us spinning the wheels. But because we had not admitted to it and had no excuse to speed he let us off.

Has anyone else gotten lucky like this?

Link to comment
https://www.sau.com.au/forums/topic/156451-got-lucky-hooning/
Share on other sites
allblitz Grand Master

allblitz

Posted
Posted
I was with my bro who's 24. He was on the freeway and off the freeway span his wheels a bit because it was wet. A few KM's down the road we get pulled over by a cop who had been following us since the free way. The cop clocked us at 122 and saw us spinning the wheels. But because we had not admitted to it and had no excuse to speed he let us off.

Has anyone else gotten lucky like this?

Hard to spin your wheels while on a freeway at a constant speed ;)

doxximus Grand Master

doxximus

Posted
Posted
I was with my bro who's 24. He was on the freeway and off the freeway span his wheels a bit because it was wet. A few KM's down the road we get pulled over by a cop who had been following us since the free way. The cop clocked us at 122 and saw us spinning the wheels. But because we had not admitted to it and had no excuse to speed he let us off.

Has anyone else gotten lucky like this?

in before lock!

tard.

RCHOO Grand Master

RCHOO

Posted
Posted
I was with my bro who's 24. He was on the freeway and off the freeway span his wheels a bit because it was wet. A few KM's down the road we get pulled over by a cop who had been following us since the free way. The cop clocked us at 122 and saw us spinning the wheels. But because we had not admitted to it and had no excuse to speed he let us off.

Has anyone else gotten lucky like this?

Bla Bla Bla....crap

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • 33GTRV
      Rb26 iron block limit

      By 33GTRV · Posted

      Here is a recipe. Sonic blocks till you get one that has a good enough bore. Get a torque plate and block brace, use your choice of fasteners (arp ect) bolt the thing together empty, half fill it and let it cure. Release it when it has, go to a REPUTABLE RB Builder and get the thing line bored/honed and cylinder honed to size, then wash. Once its all clean and dandy, wash and blow it out again. Then again.  Assemble said engine to your desired clearances with oil control mods, gasket to suit desired CR/Squish ect. Attach your extended sump with proper trap door oil baffles and head drain plumbed to sump with a SUMP BREATHER SYSTEM. Build your front diff with a decent LSD, rebuild your transfer case with a few extra plates, more than likely replace your tailshaft centre bearing and tighten up the rear diff. Tune to minimise excessive midrange cylinder pressure (timing unless you like to split bores and rebuild engines) Enjoy your engine, but hate the fact you are now destroying engine mounts, gearboxes, gearbox mounts, diff output flanges and driveshafts, diff mounts, tailshafts and front CV's.   Disclaimer.... Ive never done any of the aforementioned stuff.......
    • GTSBoy
      R32 GTS (RB20DE) Injectors Replacement

      By GTSBoy · Posted

      440s will support well over 400HP on petrol, which is a decent place to be for an RB20. 230+rwkW. Will be a safer bet for idle/low load. 550s would be nice for the extra headroom. I've made the same decision with mine (Neo25). 1000s are probably too big for the Nistuned ECU, so I have some smaller ones.
    • GTSBoy
      RB25DET Series 1 & Series 2 Gearbox Identification

      By GTSBoy · Posted

      thumbsup
    • AdiR34
      Did tie rods. Steering now not "springing" back.

      By AdiR34 · Posted

      Appreciate everything guys. I did go ahead and get an alignment... most of my complains are solved. Car is not perfect, but it's good enough. If I notice uneven tire wear or anything I'll just take everything back to stock.  Thanks again!
    • GabsReDeal
      R32 GTS (RB20DE) Injectors Replacement

      By GabsReDeal · Posted

      They still have not shipped the 550cc injectors as they weren't in stock, so in theory I could ask to get the 440cc ones instead, if those work better in my scenario. They're the same price so really shouldn't be an issue. Unfortunately I am not so knowledgeable in most parts of tuning so I wasn't sure what's best to choose between the two. 440cc ones are the lowest they have (not in stock, but available to buy nonetheless).
×
×
  • Create New...