Jump to content
SAU Community

Recommended Posts

Hi Guys

I was just wondering if some or most of you guys who have R33 GTST have upgraded your clutch and brakes from the stock ones. Have most of you upgraded cos you have greatly increased boost/power and it is a requirement? Have you found them to be a great investment?

Have you guys also upgraded your suspension too? Is it a good upgrade to consider or does the stock suspension work good enuff?

Also what have you changed these parts to?

Thanx

Kev

I suppose it depends on what you want to do with a car.

Oh... and i drive an R32, and on the street i drive like Morgan Freeman in Driving Miss Daisy.

Suspension.

I was happy with King Springs, little lower for mainly aesthetics, for the street. Drove nice, a little less roll, but no susp setup will allow you to fly around corners on Syd roads, (nor should you really want to) bumps/potholes/children. With me behind the wheel i think i would have struggled to find the limits of the chassis with this setup on the road.

But when i first started venturing onto the track i found the car wasnt that impressive so made sensible mods to improve handling whilst still preserving my sanity on the street. Bilsteins, sway bars, strut braces, bushes, alignment

Clutch

My thing was starting to show duress after numerous trips to the track. So before it caused possible gearbox damage i upgraded to a 6 puck sprung centre clutch with lightened flywheel.

For the street though my stock clutch was holding up fine remembering i only have IC/exhaust/filter/boost.

Brakes

I would like to believe that you would never approach the limits of the Nissan brakes on the street, (if serviced and functionining to their potential) As they held up extremely well on the track. You would have to show some mercy to make sure they lasted 20 minutes of abuse, but i cant see such a level of performance ever being required on the street.

That said when i cooked some pads one day at the track i did some damage to rotors as well, so seemed like the time to upgrade. Having rebuilt calipers/master cylinder/booster and running braided lines i was advised that larger rotors is all that i needed. So now have 330 x32mm rotors and the car stops like a champion for full 20 minute session (remember i only have about 150rwkws at best) Dont have to show them any mercy at all.

I have noticed that the brakes do work harder when running good rubber on the track vs crappy road rubber, which i suppose makes sense. With say another 40-70+kws and running soft rubber i have been advised that better calipers and floating discs would be ideal.

So me thinks for the road, provided the OE gear is in good nick, then springs and clutch (say around $1000) is all that you would need. Brakes some good pads and fluid works wonders.

But if you have the coin...

Thanks for the opinions roy.

I probably wouldn't venture on the track anyways, so I guess some of the performance improvements you experienced would not be felt on normal roads.

U reckon there is any need for strut braces on the road? (or do they just look cool in the engine bay) :D

Brake upgrade: The DA slotted rotors and EBC greens front and rear have dramatically improved the braking performance. Shorter stops, less fade. Pads will squeek at low speeds but stop after a couple of hard stops as dust is removed.

Initial bite tends to cause front lock up when emergency stops, not a problem for me as I have ABS, but can be avoided by applying brake pressure lighter and ramping up as weight tranfers to front (just like a motorcycle).

  • 1 year later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...