Jump to content
SAU Community

Recommended Posts

You can look it up in the Skeptics Dictionary - you'll find it between Haunted Houses and Homeopathy. To quote

"Hiclone promises fuel savings of up to 20%, power increase of up to 15%, and hydro carbon emission reductions of up to 30% with prices from $160-$215 (Australian). They'll even sell you something called Fuelmax which "is a magnetic frequency resonator which clips onto the fuel line and 'fractures' the passing fuel, allowing it to mix with oxygen more readily and thus burn more efficiently." This should keep you laughing for up to ten minutes"

The results were certainly good, although I onnly laughed for 5 minutes - perhaps because I'm an old bastard and remember the Brock Polariser and such.

Link to comment
https://www.sau.com.au/forums/topic/159841-use-of-hiclones/#findComment-2968915
Share on other sites

You can look it up in the Skeptics Dictionary - you'll find it between Haunted Houses and Homeopathy. To quote

"Hiclone promises fuel savings of up to 20%, power increase of up to 15%, and hydro carbon emission reductions of up to 30% with prices from $160-$215 (Australian). They'll even sell you something called Fuelmax which "is a magnetic frequency resonator which clips onto the fuel line and 'fractures' the passing fuel, allowing it to mix with oxygen more readily and thus burn more efficiently." This should keep you laughing for up to ten minutes"

The results were certainly good, although I onnly laughed for 5 minutes - perhaps because I'm an old bastard and remember the Brock Polariser and such.

Gav, Ant fit a polariser to your car, and it's making 1000hp now :)

Link to comment
https://www.sau.com.au/forums/topic/159841-use-of-hiclones/#findComment-2970709
Share on other sites

Those so called magnetic stuff are crap. Same as broquet fuel catalyst or what nots. Wtf would something invented in WW1 be so amazingly applicable today that major maufacturers don't implement it? Think about it. Manufacturers would boost their sales if they can increase their fuel efficency with just a few hundred bucks. After all... whats a few hundred when u're paying thousands? Every car manufacturer, esp in the economy class, toyota, mitsubishi, etc.. are trying to get better fuel economy so as to promote their cars, you'd think something as "proven" as fuel magnets and stuff like that would make their way into the production line if it worked.

So cut the crappy stuff out, and think for a while. It's all a placebo. " I paid good $$ for it and it definitely works, cause if it didn't i'm as good as a sucker"

Link to comment
https://www.sau.com.au/forums/topic/159841-use-of-hiclones/#findComment-2972738
Share on other sites

Sorry if it was too blunt and harsh, its just that i've got wayyyyy too many friends who paid good $$ for this kinda stuff to try to improve fuel economy and get more power. And they swear by it, and it just gets a lil irritating sometimes. The best way to get better fuel economy out of your car is always your right foot, and of course your necessary maintenence, tyres and tyre pressure, etc.

Link to comment
https://www.sau.com.au/forums/topic/159841-use-of-hiclones/#findComment-2973020
Share on other sites

Guest
This topic is now closed to further replies.


  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...