Jump to content
SAU Community

Recommended Posts

I think it's only the ones on the Hume HWY bypass that snap you over distance.

I'd imagine it would be too hard to do the same on the Ring Road, with the variable speed limit.

To clarify, it's the Craigieburn Bypass/Hume FWY which has the "Time-Over-Distance Speed Camera's".. the Hume HWY is still the north end of Sydney Rd.

The Western Ring Rd only has fixed/variable speed cameras, which have all been replaced now, so if you check your speed before you get to them it's all good.

There's a few speed cameras on the Hume Hwy as well, like there's a Dual Speed/Redlight Camera on cnr Barry Rd and Hume Hwy, 1min South of the Ford H/O. Also another at Sydney Rd cnr Gaffney St.

Oh and btw the Time Over Distance cameras on the Craigieburn Bypass are completely obvious if you're looking for them.. slightly harder to spot at night tho... esp with the distracting, blinding neons on the bridges right next to them.

  • Replies 42
  • Created
  • Last Reply

Top Posters In This Topic

doesn't really worry me though as i'm hardly ever on freeways :)

as long as they don't put anymore cameras on sydney rd :D i think i go over that road (between barry rd and bell st) atleast 3 times a day.... :sick:

Edited by R-SPEC

Yes, But where are the time/distance cameras on the ring road? They are up there somewhere. It was all over the media, people were bitching about it because they were going up just in time for the easter holidays........

  • 10 months later...

Pardon me for raising this thread from the dead but I have actually had a run on West Ring Road today...

I think I ran past the first fixed safety camera location in Laverton North doing around 115-120 KM/h. Then I realised that I have sped and slowed down to about 90-95 KM/H for most of the journey from then onwards.

Am I gonna get a fine of "Speed by 10 KM/H or more but Less than 25 KM/H $215.00 3 Demerit Points" or will I be "ok?"

I have not had a speeding fine for over 7 years and have all my demerits points so this upsetting as I am usually a careful driver. I am planning on applying for an "official warning" if I do get the fine... not sure if it will work though.

Opinions?

Edited by Modena

I drive on the ring road 7 days a week, and pass through 3 camera points on each trip to and from work. I know where the 6 camera locations I pass are, so I make sure I'm at the limit at those points.

I don't really speed excessively period, but in 3 years of doing that you'd think I would probably have gone faster than the point to point time (if there even is a point to point system in place on the ring road) and I've never copped a fine.

They're a bit shifty with the roadworks at the moment too...putting an 80km/h speed sign about 50m before a camera point...Coulda sworn there was a law that says the speed can't be changed within 200m of the camera point...or if it is, the camera can't get you for being over that speed...

You'll probably just get the first fine from the first camera. I'm 90% sure the WRR cameras aren't speed over distance, just speed as you pass them.

yeh i think its just eh cragieburn bypass that are the distance ones :laugh:

They're a bit shifty with the roadworks at the moment too...putting an 80km/h speed sign about 50m before a camera point...Coulda sworn there was a law that says the speed can't be changed within 200m of the camera point...or if it is, the camera can't get you for being over that speed...

Yeh I saw that the other night, just before the pascoe vale road bridge, the 80km/h sign was about 5m infront of the lines on the road for the camera....dunno what speed I was doing but it was prob somewhere between 80 and 100...will see if the fine comes :thumbsup:

Yeh I saw that the other night, just before the pascoe vale road bridge, the 80km/h sign was about 5m infront of the lines on the road for the camera....dunno what speed I was doing but it was prob somewhere between 80 and 100...will see if the fine comes :thumbsup:

Contest it if it does come

  • 2 months later...

Update for those who chimed in:

About 5 weeks ago I got the fine in the mail...i got done doing 9 KMs over the limit.

Because of my proven clean record I applied for an official warning... and today I got it :rofl:

They waved the 130 buck fine plus the demirit points.

So for those with clean driving records that got done by a fixed speed camera... ask for an official warning!

Edited by Modena
^^ how did you do that?

if you have a clean driving record for 3 years you can apply for a warning. I got my first fine 5 days before I got off my P's...had it been 5 days later they would have granted me the warning, but instead they sent me a letter saying that as I hadn't had 3 full years of driving (L's don't count unfortunately) the fine would stand.

i mean whats the process?

you have to send a letter stating that you're applying for a warning based on your flawless driving record etc...

I'd give you the address/details, but I don't have em on me anymore.

PM saff_cossie...he should be able to give you the info you need

if you have a clean driving record for 3 years you can apply for a warning. I got my first fine 5 days before I got off my P's...had it been 5 days later they would have granted me the warning, but instead they sent me a letter saying that as I hadn't had 3 full years of driving (L's don't count unfortunately) the fine would stand.

Well I wrote off my folks commodore when I just had my Ps for 3 weeks :rofl:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Well, this is probably where a wiring diagram and a multimeter come into play.
    • I can say to anyone thats doing this; having done a number of R clusters; just be careful if its an unknown cluster.  It takes a bit of force to pull up; but if it feels excessive then its probably stuck. I've had this and pulled the entire hair spring out; and I can tell you; its not easy getting the correct spring replacement with the correct inner diameter and winding. In my case someone had used some sort of adhesive to stick it to the spindle and it pulled the whole spindle out; which the force seperated the hairspring from the spindal and caused it to deform.  You may have to clean it (IPA); or in my case if i'd known i should have used some sort of solvent on it.  Also check out Cruizin Central on eBay. He does all sorts of dials; and you can email him with any custom designs you want. So if you want like certain logos etc...he'll send you a mock of what it will look like then you accept the order and he'll take care of the rest. Fantastic dials and he can do basically any design you want. 
    • Have you confirmed its the actual axles? Also the wheel bearings that mount on the hubs to hold the axles wear out. I replaced mine as they got play in them. It sorted my play issue. 
    • Ive converted a few clusters for the R33 with 320km/h dials. On the back there are some pads which can be bridged or unbridged (using solder or wick braid) to calibrate it. There is one bridge which is for MPH <> KPH; and there are combinations of bridges to offset it. There is probably a diagram  For example; this is my conversion for a 180km/h dial to a 320km/h dial (I put custom GT-R dials on it with the GTS25t layout) If you have J2 soldered (assuming the S clusters have a similar config to the R clusters); you may need to remove that solder
    • Back on topic 😉, these are some of the notable pages from the booklets that are supplied with each weekly parts update. I never knew the BNR32 test mule car had an S13 Silvia front end... *Edit: On closer inspection the test car still had the R32 body, but only the front end had Silvia panels etc.
×
×
  • Create New...