Jump to content
SAU Community

Recommended Posts

and their high magnitism towards police cars

I'd say it was the other way around. Police cars are magnetised towards Skylines, not the other way around.

Skylines are more magnetised towards telegraph poles and kerbs.

  • 10 months later...

im a bit late for this post.. but rb25 rods are knowed to have week bolts for the bearing cap.. ( where they fail) any one got any ideas what they could handle as i have had mine shot peened and arp bolts fitted..

ive never had any drama's.. even with atmo bov's

it has been a dream.

fuel consumption is good. 350-400kms per tank.

weakness is probably the wheels, tyres, clutch, diff. upgrade and your set.

BUT.... i have had to replace a few components, just as a maintenance thing. be prepared for belts, 02 sensor, aircon regas, tyres, LOTS of good oil and maybe some electronics.

AND I HATE THE BLOODY R200 diff. bloody single spinner. so shim that up aswell.

My family has owned 3 Skylines:

2001 R34 GTR

1997 S2 R33 GTS-T (202rwkw - Basic mods)

1997 S2 R33 GTS-T (255rwkw - Quite heavily modified)

Main weaknesses i have found so far are:

- stock clutch on R33 (needs changing at around 200rwkw)

- stock turbo on R33 (needed changing 1 month after raising boost)

- interior build quality on R33 (generally not bad however bland and prone to rattles)

- expensive parts and maintenance on R33 & R34

- stock suspension on R33 (was too soft and needs to be upgraded)

- MFD screen on R34 (sometimes would have a red line down screen when first turned on)

- tyres on R33 & R34 (good tyres are needed to fully exploit handling, particularly R33, and get expensive especially with bigger/wider rims)

Strengths include:

*Diffs and gearboxes have been rock solid

*Stock engine internals will reliably handle heaps of power

*Brakes are strong with good pads but can be prone to squealing

*So many other things I don't have time to mention

well when i bought my R32 gts-t it had a bad airflow meter and the transmision oil was black and the brakes where gone and the engine fuel was gone and the radiator was leaking and the sparkplugs were dead the tyres were bald and guess what the car beat a v8 and goes as hard as hell like there is no problems in the car. mate these cars can handle alot of abuse and the car still goes. when i went to the mechanic he said how did u drive this car here? it should have a blown engine by now but it didnt, after alot of fixing and tuning the car is now a monster. i have to say the skyline engine is the strongest engine i have seen. japanese people know how to build there cars :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • This is the GTR fuel pump. Yellow shows 12V, orange shows earth. The ECU provides the earth to activate the fuel pump relay. The ECU side of teh relay will pull low when the ECU activates. This is the RB20 fuel pump. Almost the same, but a little simpler. You can see I indicated (above) where the 12V line goes down to the RB20 diagram on the overall diagram, whch shows both RB26 and RB20. This is where I show it coming in on the RB20 diagram below. You can see that the dropping resistor is handled differently. When the fuel pump control is not providing earth to the pump, the pump earths through the dropping resistor and thus runs at lower voltage (some is wasted over the resistor) and runs slower. I showed that "not 12V and not quite earth" portion of the wiring in a paler orange. The rest of the wiring that I did not colour on that little section below the pump would be orange when the fuel pump coontroller is providing earth. This drop is handled inside the fuel pump controller in the GTR. Regardless, you can see where 12V is supposed to be, where earth is supposed to be. The key on prime is via the ECU providing the pump for only a few seconds the switching off. You should be able to see that happen.
    • Yeah so when you turn key to IGN the fuel pump should run for a few seconds. If you find the fuel pump relay (and have a multimeter, and a second person) to can check the relay inputs.  One trigger pin should be either fully earthed  The other trigger pin should get 12v from the ECU for say 3 seconds when you turn key to IGN, and at all times that key is at START (note, I said this from memory, it may be the other way around, ie one pin always has IGN 12v and the earth has continuity to earth when you turn the key) One Pin should have a good battery voltage The last pin goes to the fuel pump + Also note that if the power to the relay is good, and the relay is working, it is worth checking the pump has a good earth too. There is a computer in the standard system that increases the earth resistance to slow down the pump when not required, pretty old school and it may have failed
    • All this talk about fuel and fancy ECUs, meanwhile my poor old R32 has neither.... When the ignition is turned on, should there be power running o the fuel pump constantly or just for the few seconds it usually takes to prime the pump? About to go have another look at it, have watched some YouTube vids on how to use a  multimeter and looked at some wiring diagrams but really have NFI what I'm looking for because electricity is invisible  
    • Yuh....but weren't all the supertourers, except maybe the Audis, FWD? I don't recall any of the others being AWD.
    • They ran them in Oz Super Tourers too https://www.supertouringregister.com/register/vehicle/212/ (I'm so old I remember racing with Matthew Fox) They ran them in Oz Super Tourers too https://www.supertouringregister.com/register/vehicle/212/ (I'm so old I remember racing with Matthew Fox)
×
×
  • Create New...