Jump to content
SAU Community

Recommended Posts

wheels and cooler gone.. most likely thieves looking for a cheap thrill with some profit on the side.. feel bad for whoever it belongs to. hope its no one on here!

haha chances are they are on here and WOW isnt that like the 20th burnt out car on gorge road? Could have been someone going for a bit of a sideways cruise, crashed, salvaged the cooler andwheels and said it was stolen?

just a thought, just a thought.

hey just noticed me and a mate pulled over at that exact spot a while ago to take a wizz...small world...heaps of rubbish lying around but the roads kinda busy most of the time.

Could have found a better place to do it maybe.

They must be noobs at burning out cars. Interior appears its in okish condition considering.

Either that or they set it alight right next to a fire station........ :laughing-smiley-014: Sorry not really a laughing matter for someone!!

Edited by Deluxe

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...