Jump to content
SAU Community

Recommended Posts

  • Replies 111
  • Created
  • Last Reply

Top Posters In This Topic

are you in a mood to sell off the intake pipes from the pods? and the centre dash trim?

if you are, ill take them.

Edited by SLIPPERY

NEED THE LOT GONE THIS WEEKEND AT CHEAP CHEAP PRICES BRING YOUR TOOLS CAUSE YOU WILL NEED TO RIP IT OUT YOUR SELF WITH MY HELP IF NEEDED PM ME WITH WHAT YOU WANT

alloy radiator

motor

box

diff

seats

coola

hks piping kit

hks suspention

after market front top control arms

hks bov

twin 3"off each dump to single 4" to single hi flow muffla to hks super drager tip

so much to mention

Edited by ANK
can you pm me a price for the HKS piping kit? ive been after one for a few months now :mrt:

tell me what they normaly go for and i will deside please pm me as well u able to pick it up also?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...