Jump to content
SAU Community

Recommended Posts

Got mine.

Thx heaps

just 2 questions.

Where does it say ADR approved?

And it says on the bottom that mine is for R33 gtst but i have r34 gtt.

That wouldn't matter would it?

  • Replies 97
  • Created
  • Last Reply

Top Posters In This Topic

Yeah everyone should have them today I think. Ask at PO tomoz if you haven't got it by tomoz arvo.

Fuji, I haven't actually seen them in person yet sorry. I'm sure they would have sent you the right one. Heaps of stuff is interchangeable between 33 and 34.

Hi

is the R33Gtr lines the same as the Nissan Stagea 260rs? Its got the samebrembo callipers and rotors as the R33GTr. Are they available for my rig? ANd are the clutch lines still available?

If not are you going to organize a second GB in the futre? THanks

Yeah everyone should have them today I think. Ask at PO tomoz if you haven't got it by tomoz arvo.

Fuji, I haven't actually seen them in person yet sorry. I'm sure they would have sent you the right one. Heaps of stuff is interchangeable between 33 and 34.

Got mine.

Cheers...

KJ

  • 2 weeks later...
  • 1 month later...

Hey Adam,

I missed this.....any chance I can still get it done?? :D

(I know you said its closed but worth a try!!! :( )

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
    • Yeah - I mean, go the other way. Smaller range. Not larger.
×
×
  • Create New...