Jump to content
SAU Community

Recommended Posts

Just wanted to let everyone know, I've just had cruise control installed by nigel from www.cruisecontrol.com.au

$800 installed and it works great - and hopefully will keep my licence intact :nyaanyaa:

stalk looks like this (set, resume, accel, decel, and 2 memory speeds (eg 110 and 60).

cruise1.jpg

sorry out of focus

cruise2.jpg

control unit and throttle looks like this

cruise3.jpg

control unit hidden behind ABS

cruise4.jpg

Link to comment
https://www.sau.com.au/forums/topic/179321-cruise-control/
Share on other sites

This looks great, i will have to get one.

Whats the minimum speed set? My sisters only goes down to 60, but 40+ would be good cause school zones are painful.

And what is the maximum? again mysisters is gay and wont let you set it higher than 109km/h which is gay for highway as i like to do about 115.

Link to comment
https://www.sau.com.au/forums/topic/179321-cruise-control/#findComment-3268086
Share on other sites

the stork looks awfully low down isn't it a bit close to ure nee?

i was looking at getting cruise put in also but i don't really want another stork can you get buttons on the dash in stead or somthing else?

Link to comment
https://www.sau.com.au/forums/topic/179321-cruise-control/#findComment-3271737
Share on other sites

the stork looks awfully low down isn't it a bit close to ure nee?

i was looking at getting cruise put in also but i don't really want another stork can you get buttons on the dash in stead or somthing else?

I hate the stalk ones - the rostra ones I have use a rf linked control (so no wires) and clip onto the steering wheel. You can even unclip it and hand it to the wife in the passenger seat and she can make the car go faster or slower until she is happy.. :-)

Link to comment
https://www.sau.com.au/forums/topic/179321-cruise-control/#findComment-3271922
Share on other sites

  • 3 years later...

http://www.skylinesaustralia.com/forums/Sh...nt-t339098.html

---------

in reply to this thread:

DO NOT DIY IT! if you get the linkage wrong you can jam the throttle. not the most ideal thing with you stand on the brake and the car WILL NOT slow. pay someone.

Link to comment
https://www.sau.com.au/forums/topic/179321-cruise-control/#findComment-5487987
Share on other sites

http://www.skylinesaustralia.com/forums/Sh...nt-t339098.html

---------

in reply to this thread:

DO NOT DIY IT! if you get the linkage wrong you can jam the throttle. not the most ideal thing with you stand on the brake and the car WILL NOT slow. pay someone.

clutch in? engine off clutch out, brake => all good

Link to comment
https://www.sau.com.au/forums/topic/179321-cruise-control/#findComment-5489658
Share on other sites

had a reply back from the guy on ebay

Hi Tom,

The unit is fully electronic OE unit (Delco). It uses a magnet on the tail shaft to measure the speed and controls the throttle from the unit.

It will suit a turbo motor as there are no vacuum connections required.

You need to connect the control cable to the throttle (universal brackets are supplied).

should be about $200 which sounds more reasonable to be (especially being a uni student and all) and should be a case of plugging a few things together and away you go :)

Link to comment
https://www.sau.com.au/forums/topic/179321-cruise-control/#findComment-5493565
Share on other sites

i have aftermarket cruise on my s2 stag and its awesome

i looked into the magnet ones and the big problem is when the magnets come off and finding replacements, the awful panel, and getting a good spot to attach the kit. Plus i found that after so many revolutions the cruise will not opperate so it has in effect a speed limitation.

highly recommend getting one with a stepper motor instead of an extended reservoir vac tank also.

mine is a little slow to rect on hills etc although turning up the gain will help but CBF

covered 3000kms towing in 2.5 days and the cruise was awesome

when installing it i went for a stalk in the end although i already had a cm21 (for ap models) steering wheel remote CBF attaching it and went lazy stalk

why go magnet when the stock ecu has a speed wire to tap into?- this way it never runs out of scope likethe magnetic ones do.

if you are looking for a cheap option i will off load the cm21 for $50 (cost $140) as its useless to me and it has never been used! (a little sly selling stuff here...) - just need to buy the stepper motor then and tap into the loom.

vs55216-thum1251.jpg

Link to comment
https://www.sau.com.au/forums/topic/179321-cruise-control/#findComment-5494402
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...