Jump to content
SAU Community

Recommended Posts

I own a GTST Series 2 R33.

Does anyone own one aswell and is running a slide highflow?

Compared to stock turbo how much laggier is it?

What sort of kws u getting out of it?

How long u had it on your car for?

Mods Include -

POD

FMIC

Power FC & Controller

Apexi Boost Controller

Soon to have 555c injectors

Would i need anything else? would it puch 260kws on a SAFE tune?

Thanks

Link to comment
https://www.sau.com.au/forums/topic/184705-slides-highflows/
Share on other sites

My cousin has one on his R33, just with cooler, turbo back exhaust.

Doesn't seem muc laggier, only a little.

Pulls very strong on boost all the way up to red line. He has had it for at least a few thousand km's with no issues.

I also want to get one for my R32, but SLIDE doesn't make any high flows anymore..

VG30 max over size high flow would be better for 260rwkw and above.

Edited by abu

But GCG do Ball Bearing not Journal... so itll spool like 100-200rpm faster or someshit like that.

If you ask GCG maybe theyll do a Journal Bearing for cheaper.

Edited by Pauly33GTS-t
Yep same problem here.

Not I am also undecided on what to get.

Just a a HKS2530 or something similar to that, maybe even a HKSGTRS.

yer my problem is i dont know enough about turbos to make a good decision!

If you are only looking to make 300 rwkw or less i would vote the GTRS or the GT28rs hands down.

Anything over this and you would be looking at something like the GT3071 or something similar.

From what i have read these are the two best turbo's for around the 300 rwkw mark without losing too much driveabiolity as an everyday car.

Guest
This topic is now closed to further replies.


  • Latest Posts

    • Kinkstah, no, coilovers aren't illegal, especially as a bolt straight in. The illegal part will be if they're altering suspension geometry beyond factory limits, or the ride height is not legal.   Sounds like the blue slipper just didn't want to deal with any later possibility of mods appearing on the car.
    • The problem has always been that coilovers are able to be adjusted, almost at any time, to be too low. Most people who ever get/got defected for/with coilovers were actually afoul of the minimum ride height rule. So the interpretation by cops/inspectors was always that it is pointless to allow numpty to raise his coilovers and get the car inspected/cleared, then just drop them back down again as soon as they get around the corner from the inspection station.  This led to the interpretation that they were illegal unless rendered such that they can't be adjusted (ie, collars welded to the body, that sort of thing). That may or may not have ever actually been the official line, but I'm pretty sure it's not considered to be a solution these days. Coilovers themselves fall under clause 3.2 b of that manual, because they are an "installation of a variable ride height system" and they don't fit the exclusions in that clause (which point to air springs and other pneumatic adjusters). So, as per previous statements, they require engineering cert to be legal on the road. Once you have such cert, provided you do not adjust them outside the height range covered by the cert, you are OK. Without, you have an unroadworthy vehicle.
    • Here E10 is the cheapest fuel. And general advice is to not use it unless you hate your car. From what I remember it clogs up stuff in the fuel system or injectors?  With US/Canada being E10 across the board, does that mean that all fuel there is terrible?
    • Sorry, are coilovers ACTUALLY ILLEGAL in NSW? They aren't in Vic, as long as they retain 70% of stock travel and the car is above 100mm off the ground. Does NSW actually have a law making coilovers actually illegal? RWC/Blue Slip/Engineering people not knowing the actual f**king laws boils my blood. Demand them to point to the documentation that states a coilover is illegal. (it may exist in NSW ) Edit: I checked. They aren't. https://www.nsw.gov.au/sites/default/files/2021-02/RMS-infosheet-light-vehicle-modifications-manual-suspension-and-ride-height.pdf
×
×
  • Create New...