Jump to content
SAU Community

Recommended Posts

woot :laugh:

my refund is going towards "security", paying off my clutch, finally powdercoating my rim, paying off the tiny remainder left on the credit card, maybe slot my standard rotors (if they can be?), fuel pump and maybe injectors :D

woot :laugh:

my refund is going towards "security", paying off my clutch, finally powdercoating my rim, paying off the tiny remainder left on the credit card, maybe slot my standard rotors (if they can be?), fuel pump and maybe injectors :D

Where are u getting the rim powdercoated? Would like to get my engine cover and calipers done...

-D

Where are u getting the rim powdercoated? Would like to get my engine cover and calipers done...

-D

Can do, they will prob do it cheaper if its all together. Anyone else need stuff done?

Where? hmmm. RYAN!!! where did you tell me to go to have it done??

there is a powder coater up here in holden hill, havent been there before, but heard they do a good job.

are you implying that i am a useless whore damo? ha ha

Edited by craig R33

Well if you add all that up, its not much.

my refund is going towards "security" $345, paying off my clutch $700, finally powdercoating my rim $50, paying off the tiny remainder left on the credit card $200, maybe slot my standard rotors (if they can be?) not much <$200, fuel pump $150ishand maybe injectors $700ish If i add all that up, i still have a good amount to save.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
×
×
  • Create New...