Jump to content
SAU Community

The Sa Wasteland

Cubes

By Cubes,
in South Australia

 Share

Recommended Posts

  • Replies 36k
  • Created
  • Last Reply

Top Posters In This Topic

  • Damo_R34

    2820

  • scandyflick

    2266

  • Madaz

    1919

  • craig R33

    1717

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

Ryanrb25
Ryanrb25

i went for a hills run last night in the 31 with the roads very slippery.....was much fun. Had to bed in the bottom end bearings so yea..took it for a strap.

DSTROY
DSTROY

Hey Ryan, do you know how to fit a set of drop spindles to the front of a hilux???

Madaz
Madaz

Dam straight Damo would rather do SAU them heroin gts4 are 4.1 because they share the same parts from the gtr i think r32 gtst is 4.3 because of the lack of torque from the rb20

Posted Images

kralster Veteran

kralster

Posted
Posted
Could be a number of things:

Plug gap (even the factory can be lazy). You could cut to the chase and just fit iridiums.

Fuel. What you using?

Was there any sensor device on the bike originally, like in the area of the cat? If thats left unplugged the ecu might not account for it.

If its still running the stock filter, that might not help either. Hard to say without knowing fully how flexible the ecu is with realtime tuning.

I know my TLR doesn't like short trips. Fouls plugs on short distances ... needs to be warmed up completely and have a few kms on it once warm. Maybe the CBR does the same thing.

Most of the time its not just one thing on its own, its a combination. But the pipework (and removal of the cat) could be the main problem. I know I had to re-fit the eMoto hi-flo system and mid pipe on my Brutale when I got it back from the repairers. The stock cat was killing fuelling and throttle response because it was tuned for PULP and a hi-flo system.

If you really want to be spot on. Take the bike with a tank full of PULP, a fresh set of iridiums, to Neville Lush in Victor Harbor. He's a guru with tuning and I've never had a problem with any of my bikes thru him.

Where is the bike now (who is fixing it)? I might know the guys and can get a bit more info.

Hey,

I was thinking of changing the plugs anyway so i may get that done next service.

I usually run bp ultimate, but when i've been in the middle of no where it's run on 95 octane no probs.

I honestly haven't bothered to look if there are any sensors unplugged due to the exhaust. All i know is that the servo motor cable is obviously gone as i've got the akrapovic exhaust.

I used to live in victor harbor so i know neville lush. I think maybe sometime soon i'll get new air filter, plugs, power commander and get it all tuned up.

Inline 6 Grand Master

Inline 6

Posted
Posted (edited)

your in luck ryan with my skating career it just so happens ill be in need of a spare set of balls incase of a hand rail incident.

http://www.metacafe.com/watch/1468717/skat...ole_with_groin/

how shall we arrange the exchange for this car. yes im joking strange people

:D id recomend keeping them mate what the hell you gonna do when that car pulls chicks without em

Edited by Inline 6
Inline 6 Grand Master

Inline 6

Posted
Posted (edited)
f**k yeah, just got back from the casino, Won $350 woo only spent $20.

dude seriously dont tell me you becoming a damn addict.

and you better not have been playing that war game, the rolutte wheel has better odds man i can give you the numbers if u like :D but both have you sitting at less than 50% chance of doubling your money

Edited by Inline 6
Luke_ENR34 Grand Master

Luke_ENR34

Posted
Posted

nah mate lol. A mate of mine wanted to go there and spend some money, so i tagged along. War game was closed. Won it on the Pokies. $1 machine won 25 free games, then that doubled to 50 and somehow when i got around 180 my money doubled again. Feeling awesome right now :D

Cubes Grand Master

Cubes

Posted
  • Author
Posted

I was planning on stepping out early/mid Nov until I was asked by a few to hang around as a result of SAU/SA partially being used as a pawn.

Now that its all blowing over a tad and Neil hasn't replied (a week is plenty of time) I'm out of here. :D

Joined up in 2002; bought the car in 2001. Its been a fun 8years, learnt a hell of a lot.

And finally.. If your going to present yourself as a car club invest the $$/time and do it properly then approach the Police. Remember you are representing SAU nationally not just in your little world.

Stickers etc are fine just be careful who they are handed out too as they then reflect badly on SAU/SA as a whole.

'Typically' stickers etc are to be handed to real club members; if that member is reported hooning they are booted from the club and the request is made to remove the sticker.

So keep safe and watch out for those highflows. Regency are now checking the chra's. :)

jeffbday00-6.jpg

DamageInc Grand Master

DamageInc

Posted
Posted
I was planning on stepping out early/mid Nov until I was asked by a few to hang around as a result of SAU/SA partially being used as a pawn.

Now that its all blowing over a tad and Neil hasn't replied (a week is plenty of time) I'm out of here. :)

Joined up in 2002; bought the car in 2001. Its been a fun 8years, learnt a hell of a lot.

And finally.. If your going to present yourself as a car club invest the $/time and do it properly then approach the Police. Remember you are representing SAU nationally not just in your little world.

Stickers etc are fine just be careful who they are handed out too as they then reflect badly on SAU/SA as a whole.

'Typically' stickers etc are to be handed to real club members; if that member is reported hooning they are booted from the club and the request is made to remove the sticker.

So keep safe and watch out for those highflows. Regency are now checking the chra's. :huh:

jeffbday00-6.jpg

ill miss you :D

Ryanrb25 Grand Master

Ryanrb25

Posted
Posted (edited)

Wow Joel, Didn't see that coming. You were a strong but fair Moderator :D I think i speak on behalf of everyone when i say you were someone everyone looked up to and respected for your leadership and constructive 15000odd posts hehe. All the best for the Future mate.

Ryan

Edited by Ryanrb25
Madaz Grand Master

Madaz

Posted
Posted

yeah Joel GG

don't worry guys i have a sneaking suspicion its not just up and leave and block SAU from his browser we will still see Joel about just not in an official capacity (not confirmed by Joel just my thoughts)

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • djr81
      RB26DETT Sketchy boost mod?

      By djr81 · Posted

      Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
    • PranK
      Chris' Toyota Mark ii JZX110

      By PranK · Posted

      This looks great! Awesome to have the 5 speed with an LSD in this. The Recaro's look like SR2's or SR3's. It's a shame they've been retrimmed as they would have looked sweet in their original colours. I think I'd want my agent to be a little more up front and informative too. I've never imported but I reckon it would make me a little nervous, so the more info the better.
×
×
  • Create New...