Jump to content
SAU Community

Recommended Posts

rofl,

Poll Results

Thanks for voting, here are the results so far:

Have the tougher laws introduced in 2005 reduced hoon driving in SA?

Yes

29% (43 votes)

No

70% (105 votes)

Total votes

Total of 148 votes

This is taken from the poll on hoon driving..

Pathetic creatures who "need to" do burnouts and all that childish idotic behaviour. Who says they "need to" do this? How about getting a life, some real responsible friends and a good hobby? Look at other countries. Does Europe have this problem? Not really. Let's ask them why. There is plenty of opportunities here to let off steam, like football, etc. etc. "Test their vehicles"? What for? Read the instructions: a car is a means of transport, that's all. Not a goofy toy to show off your infieriority complex and other mental disturbances to people who aren't really interested!!!

Seriously some people have no idea. Yet they feel the need to voice an opion about a subject they clearly do not understand or know anything about. F__k they make me angry.. I bet you the same person who wrote that comment is also the same type of person who drives in the right hand lane and sits 15km's under the speed limit then glare at you when you over take them even though your still going under the speed limit.

End rant.

F*ck me. I've just been trawling the Japan Yahoo car auctions, and I found 3 32 GTR's which were MINT! One was going for 24k AUD and had 21,000k ORIGINAL k's on the clock. It's been garaged for years! Only 1 owner with books to prove the k's!

And another one, had books to prove the dash board change over to prove it had 34,xxx k's on it.

So many people rant on about the k's being wound back, but there's plenty of Skylines who have little k's yet are original k's with books to prove it.

Most car ads also display the person doing a comp. test on the car, with pictures of each reading and they even show you the condition of the spark plug. Now that's what I call a decent car ad!!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Starter motors used to use the weight of metal (magnets) to provide torque. Now they use (more) current instead. This. It's completely normal.
    • So thing that had me stumped, but I think is OK....is that when it was up in the air, in neutral I had it running to bleed to coolant while I put the wheels back on. I noticed the rears were turning (slowly) which I'd never seen before 20250928_163512.mp4     Because there had been an issue with clutch slip due to pedal adjustment on the dyno, I assumed there was still and issue so spent some quality time upside down under the dash adjusting the pedal....but no matter what I did the wheels still turned in neutral. Even disconnected the master cylinder to pedal rod and same. In despair, I even removed the clutch slave so there was no chance of any preload causing it.....still happened. So either: 1. Something is not right in the bellhousing, or 2. Its a thing sometimes with cold, thick gearbox oil Internet says it might be 2, I hope so!
    • OK, few more things sorted and it is ready for a shakedown on 10-Oct, with one weird thing. Changed the run in oil and filter for the good stuff. 8l came out, about 8.5 went in with filter so that looks all good. Changed the starter (again), this time for a brand new one, works good. Interesting that the Taaaarks one is shorter than factory but spins harder, I guess electronics have moved on a little in the last 30 years. Will be nice to have a bit of extra space under there. Put the timing cover back on, and noted where the cam gears were set as a record.  Will need to double check the timing but it is pretty close. Also put the coil pack cover and intake snorkel back on. Exhaust Inlet Changed the water out for coolant, bled up nicely. Removed the rear brake pads (well worn factory sumitomo ones!), gave the hardware a good clean and reassembled. I've put bendix XP on the back again because the price is excellent at $150 a set and they worked well on the V37. Front pads have plenty so no issue there
    • Mine is all -12, I’m running a dry sump in a billet block though 
×
×
  • Create New...