Jump to content
SAU Community

Recommended Posts

fancy a lol

the guy that owns "dragon" is a member of streetcredit..... he is quite convinced that its a 180

here is a quote from the owner

HI A MEMBER OF SMASA AND I GOT 180SX CALL DRAGON SHOW CAR > ALL AIR BRUSH S15 REBUIT MOTOR 4 NOS 220KWS AT THE REAR REGO AS 2SEATER PULL ON SOUND 138 DS IT WILL BE A THE CAR SHOW FEB 8TH EMAIL ME 4 INFO THE DRAGON

His engine is not a S15 engine, it doesn't have the bump at the front of the rocker cover for the VTC solenoid that al the S14 & 15's had.

Also I though he was claiming he had 260rwkw and that he was running a T51R.

questions !

can i use an rb25 air con compressor on an rb26 and do i need to have the fans n crap on the front of the car behind the bonnet latch thingy

do rb26 pistons and cranks go into rb30 blocks

how do i tell if im missing the big aircon box thats usually under the dash

(air con blows air out so i assume it aint missing lol! )

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
    • I just stack 2 pieces of 200x50 timber on top of each other. Total length about 900mm, with the top one being a little shorter and both having a 45° angle cut on them to make the front edge a bit of a ramp. Put these in front of each front wheel, drive up on them, throw the trolley jack under. Takes 1 minute. Scissor jacks can eat a bowl of dicks. I never use on under my car unless desperate.
×
×
  • Create New...