Jump to content
SAU Community

Recommended Posts

shame on you for constantly playing along! you should have the same rules as Sam Newman, the network gives you a list of words you CANT say. you'd be pretty much limited to: "hi guys" and "cya"

you two couldnt handle muh pie even if i did make it for you :happy:

I disagree, Ruby and I could devour many a pie.

So much pie infact, Van Halen will reform and write a power ballad about the epic amount of pie we can eat...

-D

Yeah ... you're the consistent wasteland postwhore :happy:

Cara, Ben and I only whore when Cara talks about her .... cooking!

agreed. once we were on the same amount of posts i just check and now lookin ova 5000 hahahah wish i could kill time on sau while getting paid for it at work ;)

Do you add mushrooms and onion or is your pie plain?

Cos if its plain u can keep it. Dont want that pie.

-D

oh hell no ben

ok i make these lamb (can use beef) wellingtons that are to die for...........

lamb

shitload of garlic

fine diced onion

rosemary fresh

salt and pepper

gravy

puff pastry

cooked in the oven they are yummmy! wont give way how i cook them tho :happy: but also make good pie mix too

for example

my burger pattie mix also makes for good meatloaf to lol

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...