Jump to content
SAU Community

Recommended Posts

shame on you for constantly playing along! you should have the same rules as Sam Newman, the network gives you a list of words you CANT say. you'd be pretty much limited to: "hi guys" and "cya"

you two couldnt handle muh pie even if i did make it for you :happy:

I disagree, Ruby and I could devour many a pie.

So much pie infact, Van Halen will reform and write a power ballad about the epic amount of pie we can eat...

-D

Yeah ... you're the consistent wasteland postwhore :happy:

Cara, Ben and I only whore when Cara talks about her .... cooking!

agreed. once we were on the same amount of posts i just check and now lookin ova 5000 hahahah wish i could kill time on sau while getting paid for it at work ;)

Do you add mushrooms and onion or is your pie plain?

Cos if its plain u can keep it. Dont want that pie.

-D

oh hell no ben

ok i make these lamb (can use beef) wellingtons that are to die for...........

lamb

shitload of garlic

fine diced onion

rosemary fresh

salt and pepper

gravy

puff pastry

cooked in the oven they are yummmy! wont give way how i cook them tho :happy: but also make good pie mix too

for example

my burger pattie mix also makes for good meatloaf to lol

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
    • 3 Kids are starting to hit that ages. I wanted to get them something special to learn on, put down the screens and have some fun. 4Door 2001 R34DE Black Pearl GV1 Jap Import, AU 2nd owner. Pre Work done. Suspension - Wheels Pedders SportsRyder Coilovers   Wheels TSG Spokey Boi 18'x9.5"+15 Body JASI Aero 4 door Type R Full Kit LED Conversion - Parker, Blinkers, & Reverse Exhaust Hurricane Headers 100 CPI high flow cat 2.5" Piping Cannon muffler Internal Bride low max stradia ii - front seats  Bride RO seat base and Rails (R/H) Cube short shifter LED Conversion - Interior   
×
×
  • Create New...