Jump to content
SAU Community

Recommended Posts

They're really wide wheels man, the front sat nice with the guard when Jarad had just the fronts on,

Them wheels ^^ there aren't bad, awesome for the dish and yeah I agree they need the black centres otherwise too much chrome and look cheap and tacky, hmmm how much for them ^^

You getting your guards lipped?

Edited by Weezy

width doesnt concern me, width PLUS offset however, sorta does.

my old 8 +32's fouled on the spring perch. from memory, j's xd9's are wider with a similar offset, hello foulage. and im not going to run spacers.

haha, calling eurolines tacky? interesting. similar wheels to what i had on the celsior, def not tacky.

and yeah, rear guards have been lipped, ill do the fronts if i wind the coils down.

Celsior036.jpg

Edited by scandyflick
i feel like crumpet with butter and vegimeite.......wonder if stuart has eaten them all yet :)

yuk, too friggan salty

crumpets, better then pancakes but not as good as waffles.... the debate begins again...lol

how about french toast ???

My XD9's are 18x9+20 and 18x10+18. Lowest they make.

fairly sure the fronts will foul on my struts.

rears would be fine... i think.

call me a puss I cant stand it...lol

like eating a salt block, even after 9 years here I still wont eat it...lol

lol. pussy. maybe you oughtta try some of that pussymite stuff theyre marketing for you girlymen.

fairly sure the fronts will foul on my struts.

rears would be fine... i think.

lol. pussy. maybe you oughtta try some of that pussymite stuff theyre marketing for you girlymen.

nah they will fit.. mate had this fittment on his s13.. no spacers and they were fine!!

DOO IIIITTTT

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
    • Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
×
×
  • Create New...