Jump to content
SAU Community

Recommended Posts

Royal Purple FTW!!! I have run it in my past 3 cars and never had a problem with it what so ever. Oh and its a different coloured oil...i like colours :dry:

It walso did real well in quite a few oil tests. Royal purple and Penrite sin were up the top if i remember right.

Shell Helix Ultra - full synthetic 5w40 I beliebv the grade is.

Very good oil and well priced.

If you want to spend a little more I would go with the new refined CASTROL EDGE 0w40, also fully synthetic.

"Full synthetic engine oil recommended for the latest technology and prestige engines, including sports cars and luxury sedans."

Or if you have an older motor, you'd be best to use the CASTROL EDGE Sport 10w60.

"Full synthetic engine oil recommended for highly stressed competition engines, older technology sports cars and luxury sedans."

Dont know if we get that purple wtuff over here, put in some 5-40 fully synth, seems to have quitened down the noisy tappetts

40's too thick for running a turbo. Try sumthing like a 30 weight. 5's ok on the lower end, 0 would be better for starting. Think even the manual for an RB recommends a 30, sumone may be able to confirm.

There's also a sticky up top on oils.

Edited by G_Force
Dont know if we get that purple wtuff over here, put in some 5-40 fully synth, seems to have quitened down the noisy tappetts

contact royal pruple Australia directly (www.royalpurple.com.au) and if they don't have a stockist near by, they'll sell to you directly (they did so with me). I actually had my car sitting in my driveway for 10 months, and no one had started it up (despite the fact I had asked a mate to do just that!) and I got home, connected the battery, put a small amount of royal purple into the engine as a top up, on kick and it's all sweet!

It has not missed a beat or leaked while running RP.

Highly recommend.

Plenty of people say redline is better, and that may very well be true for high end applications, but if Royal Purple can be used in hot rods and drag cars (i.e. chip foose's machines) I don't see a problem with it handling my dear old RB20. Plus Royal Purple is cheaper.

I got castrol 10w-70 in the engine at the moment but im goign to swap to a Mobil1 5w-50. Cos my tuner prefer castraol and im goi nt o swap to mobil very soon. I used mobil 1 all the time and its a good oil.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
×
×
  • Create New...