Jump to content
SAU Community

Recommended Posts

Lately my R34 GT-T has started knocking under medium load. (Moderate accelleration uphill)

It seems to be down on power and chewing through more fuel, I only got around 500k from the last tank.

I had a basic service last week, but if anything its gotten a little worse.

When it origionally started happening I thought it may be a bad batch of fuel, but that was several tanks ago now and its slowly getting worse.

I was wondering if its possible for a PFC to loose its tuning, and if so, how to tell?

Link to comment
https://www.sau.com.au/forums/topic/189995-sick-r34-pfc-problem/
Share on other sites

just take it back to the tuner and ask him to take a look. maybe timing needs to be changed marginally due to the heat.
It hasent really heated up out here yet, nothing like summer which was fine, and same knocking problems in the morning when its quite cool still.

I spose I will have to make a Trip to Sydney to visit a Tuner.

Also, geez bud, only 500 km??what do you normally get??
Normally 45L for 500k, this time it was 54L for 500k.

(most of my driving is commuting to work which is pretty much just hightway cruising.)

omg.... you get 500kms a tank on a highway is about right, you're complaining?

My main concern is "has started knocking under medium load."

As for the fuel economy, I would think noting that Its started using 9L more per 500km may be useful information to working out whats gone wrong dont you?

What mods you running?

FMIC, PFC, Eboost (usually leave it at 1/2 bar when commuting), Turbo back exhaust, Pod and thats about it. No changes here for a couple of years.

Power FC won't lose it's tuning. Even if it does due to the 'heat', it is very minimal.

Ok, so it wont drift, but any way it could have been reset if the battery was disconnected or something like that?

The ecu wont loose its tune or forget so its purely just how you are driving and possibly a bad batch of fuel

500 k;s to a tank is great so dont worry there. have a read of the powerfc faq (in my sig) it will cover most of your questions

Maybe you pressed a few buttons on the hand controller or somebody mucked around with it. This happened to a friend of mine.

If it is knocking, you can retard the timing using the hand controller - back it off a few degrees start at reducing it by 3 degrees until knock doesn't go above 20. This can be done in the mean time until you see your tuner...they should be able to sort it out for free if its a problem with PFC.

Also keep in mind, the RB knock sensor is pretty sensitive and may just be detecting other engine noise.

Edited by JBird

hey bill i live in bathurst and have never seen ur car i thought the only 34s out here were mine and the yellow gtr. anyway wat servo do u use? i have similar mods besides i have the profec b spec2 and hks bov. the weird thing is that im getin beter fuel economy now that its warming up im geting about 400 2 a tank of fuel city driving. But out on the road it doesnt change even when my mum drove my car to orange as i had 2 take her car 2 sydney 2 pick family up and she isnt a lead foot and only got 14l/p100k.

Anyway it mite have block injectors witch mite b not giving it enough fuel under medium load but the ecu could b trying to corect by opening the injectors longer when not under medium load and running rich. it mite b worthwhile gettin the cat check for blockage.

The ecu wont loose its tune or forget so its purely just how you are driving
Vey easy, think less than 1/3 throttle
and possibly a bad batch of fuel
I had considered this, but its getting worse after several tanks from a couple of different servos.
500 k;s to a tank is great so dont worry there.
its not so much the k's its the sudden change
have a read of the powerfc faq (in my sig) it will cover most of your questions
Thanks, will do so.
Maybe you pressed a few buttons on the hand controller or somebody mucked around with it. This happened to a friend of mine.
The hand controller is attached and just sitting in the glovebox, so I spose the buttons could have been pressed by other stuff sitting on it.
If it is knocking, you can retard the timing using the hand controller - back it off a few degrees start at reducing it by 3 degrees until knock doesn't go above 20. This can be done in the mean time until you see your tuner...
Thanks, will do so.
hey bill i live in bathurst and have never seen ur car i thought the only 34s out here were mine and the yellow gtr.
Its hard to miss Carls :O .

Mine is a more sedate Silver.

Ive had the R34 for well over 5 years now (first one in town :O )

anyway wat servo do u use?
Either of the Shells on the highway (depends which way Im driving at the time)
Anyway it mite have block injectors witch mite b not giving it enough fuel under medium load but the ecu could b trying to corect by opening the injectors longer when not under medium load and running rich. it mite b worthwhile gettin the cat check for blockage.
Now theres a thought....

I think I might change the fuel filter and take the injectors downtown and have them cleaned.

Edited by Bill

ok yeah mines a silver 1 2. i only use the 1 on stuart st as its got all new tanks in it. i just changed the fuel filter in mine and i got more out of that tank with the same driving style. when u change the filter have a clean container and drain the filter out from the in side and give it a blow and check 2 see how dirty the fuel was that comes out of it. mine was lookin like tea

Edited by raps86
  • 1 month later...

Cleaned injectors, changed filter and ran a few tanks through it since then.

Fuel economy is better, but not back to what it was (About 1/2 way there)

Still got the knocking under load :rofl:

spark plug type and fuel filter type the same after service

I think you may be onto sonthing here.

How long should iridium plugs last before being replaced?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Look for broken wire or bad connector at the motor. Might not be it, but is worth starting there, as it is easy.
    • Hi everyone, I’m having an issue with my R32 GT-R. Sometimes, when the car goes over a bump or experiences some vibration, the 4WD warning light comes on the dashboard. When I check the code from the control unit in the trunk, it shows Code 19 – ETS Motor. However, everything seems to be working fine — if I turn off the engine and restart the car, the light goes away and everything functions normally. Has anyone experienced this before? Where should I start troubleshooting this issue? Thanks in advance!
    • I'm back from the dyno - again! I went looking for someone who knew LS's and had a roller dyno, to see how it shaped up compared to everything else and confirm the powerband really is peaking where Mr Mamo says it should. TLDR: The dyno result I got this time definitely had the shape of how it feels on the road and finally 'makes sense'. Also we had a bit more time to play with timing on the dyno, it turns out the common practice in LS is to lower the timing around peak torque and restore it to max after. So given a car was on the dyno and mostly dialled in already, it was time for tweaking. Luis at APS is definitely knowledgable when it came to this and had overlays ready to go and was happy to share. If you map out your cylinder airmass you start seeing graphs that look a LOT like the engine's torque curve. The good thing also is if you map out your timing curve when you're avoiding knock... this curve very much looks like the inverse of the airmass curve. The result? Well it's another 10.7kw/14hp kw from where I drove it in at. Pretty much everywhere, too. As to how much this car actually makes in Hub Dyno numbers, American Dyno numbers, or Mainline dyno numbers, I say I don't know and it's gone up ~25kw since I started tinkering lol. It IS interesting how the shorter ratio gears I have aren't scaled right on this dyno - 6840RPM is 199KMH, not 175KMH. I have also seen other printouts here with cars with less mods at much higher "kmh" for their RPM due Commodores having 3.45's or longer (!) rear diff ratios maxing out 4th gear which is the 1:1 gear on the T56. Does this matter? No, not really. The real answer is go to the strip and see what it traps, but: I guess I should have gone last Sunday...
    • 310mm rotors will be avilable from Australia, Japan, and probably a few other places. Nothing for the front can be put on the back.
    • The filter only filters down to a specific size. Add to that, the filter is AFTER the pump. So it means everything starts breaking your pump even if its being filtered out.
×
×
  • Create New...