Bleed Valve Instal

[gtrboosting]

Hey i'm going to attempt to instal my bleed valve today but am unsure of exactly where to connect it. I read that autospeed article but it seems i don't have the standard boost solonoid.. wel its not where the one in the pic is anyway. Which line is best? And where abouts is it? any pics would be GREAT! thanks alot

[gtrboosting]

p.s it was easy on my 180sx because i could see the actuator etc..

Edited December 4, 2007 by gtrboosting

[gtrboosting]

ok so i found the stock boost solonoid. it has 3 lines i think running off it. Should i plumb it into the line with the stock boost restricter? line with yellow ring around it? Thanks

[R338OY]

Here's a thread with pics:

http://www.skylinesaustralia.com/forums/In...st-t185848.html

It's very simple, on a GTS-T anyway.

For a twin turbo setup check the link to the turbosmart website (in that thread) and you'll find diagrams to help you.

All the best

[H@ME]

great D.I.Y write up man, i think i will invest in one of these little beauties soon.

cheers hame

[Mike__]

been covered be4 but....

Leave the stock solenoid in place but remove the restrictor from one of the lines going to it (has a yellow line around it).

Over to your turbos: Both actuators (fiddly) should be connected 2gether and branched off with a 't' piece. Exit of this t piece goes to one end of your controller. The other end needs a vacuum souce, mine uses hte line for the factory boost gauge (going to a small black box on your drivers side firewall) with a t piece. Mount your controller near the turbos. Mine uses a bolt with a earth wire to the passenger side shock tower. Buy some tubing, x2 t pieces and install a proper boost gauge.

Enjoy