Jump to content
SAU Community

Recommended Posts

Hey guys, after getting a cat back exhaust in & BOV recently, i didn't know but the ppl driving behind me goes when i full throttle or even rev it hard in neutral, it gives out black smoke ONCE out the exhaust but not constantly...i think it just gives out black smoke once when i rev it high or gun it under load....

It is running rich correct? cuz i don't have a air/fuel ratio gauge, heard the black smoke was real black someone behind me said but when i revved it in neutral hard it wasn't THAT black but i dunno how it is under load... Is it even normal for the car to run rich with just a cat back exhaust (with stock cat)???? Is it normal for skylines to run rich for safety reasons???

thanks in advanced guys...

Link to comment
https://www.sau.com.au/forums/topic/199140-black-smoke-under-load~/
Share on other sites

Work out your fuel ecconomy.

Goto a servo and fill your car to the 1st click on the fuel pump

Reset your trip meter

drive about until your down to like 1/4 of a tank

go back to the same servo/pump and refil to the 1st click

look at the bowser and note down the kms

look at how many kms you have done

divide liters by kms then times that result by 100

This will give L/100kms

post that up here.

Edited by whiter31gxe

Minor correction :D

Work out your fuel ecconomy.

Goto a servo and fill your car to the 1st click on the fuel pump

Reset your trip meter

drive about until your down to like 1/4 of a tank

go back to the same servo/pump and refil to the 1st click

look at the bowser and note down the Liters

look at how many kms you have done

divide liters by kms then times that result by 100

This will give L/100kms

post that up here.

o2 sensor is not read at full load... its only used to lean out the cruise and idle maps.

Black smoke on full throttle is generally pretty normal... but the better the tune the less wasted fuel there is, if you have a stock ecu hitting rich and retard its going to do it something chronic

o2 sensor is not read at full load... its only used to lean out the cruise and idle maps.

Black smoke on full throttle is generally pretty normal... but the better the tune the less wasted fuel there is, if you have a stock ecu hitting rich and retard its going to do it something chronic

Ill work out the fuel economy...

So your saying its quite normal to run rich with black smoke under full load on stock ecu with JUST A CAT back exhaust? (With stock cat BTW)??

Edited by R33Turbo

Other ppl on the forum says my coilpacks are on the way...would that by any chance affect the reason why i have black smoke under full throtttle??

Cuz im not really happy with black smoke, worst comes to worst an aftermarket ECU would be able to tune it out right?

Also will an aftermarket ECU tune out the BOV causing the bogging??

Wat if its a SAFC?

Edited by R33Turbo
o2 sensor is not read at full load... its only used to lean out the cruise and idle maps.

Black smoke on full throttle is generally pretty normal... but the better the tune the less wasted fuel there is, if you have a stock ecu hitting rich and retard its going to do it something chronic

Simon, while this is true, the ECU will make adjustments in closed loop to maintain the correct A/F ratios under cruise, it does also have a bearing on the entire fuel map. The long term fuel trim refers to this adjustment. Fuel maps will be altered based on the amount of trimming the ECU does during normal driving to acheive correct ratio in closed loop. If long term trims are altered say 5% to the rich side, its 5% right through the entire fuel map, not just the closed loop areas. These long term trim adjustments are maintained in the ECU until such time as battery is disconnected and trims are returned to factory settings (0 or BASE). They LEARN this to compensate for alterations to things like altitude, ambient air temp and engine wear, even driving styles.

Im willing to bet you have put a venting BOV on it, put the stocker back on and 95% sure it will fix your problems and get heaps better fuel economy.

Yep i have a BOV to dump into air...So how could that affect the black smoke richness? i dun get it....i do have alot of popping sound from the exhaust which i understand if the BOV is the cause but not really the black smoke...BTW i do have coilpacks going but theres no way it'd be the cause of the black smoke under load will it??? :D

Anyway thanx heaps im worried less as skylines are supposed to run rich to be safe.

Edited by R33Turbo
Yep i have a BOV to dump into air...So how could that affect the black smoke richness? i dun get it....i do have alot of popping sound from the exhaust which i understand if the BOV is the cause but not really the black smoke...BTW i do have coilpacks going but theres no way it'd be the cause of the black smoke under load will it??? :D

Anyway thanx heaps im worried less as skylines are supposed to run rich to be safe.

If the BOV ain't leaking when WOT, it wont effect it.

Rich still inst all that much fun. Over doing it can leave glowing carbon deposits over time. Recommend grabbing something and trimming it out

" black smoke ONCE out the exhaust but not constantly" Im a bit confused as to when it is blowing smoke. A venting BOV will blow black smoke and make it run rich on gearchanges, as the ECU thinks that air coming out the BOV is going through the motor, so it adds the corresponding amount of fuel. When you change gears it fuels the motor up, then when you accelerate again it comes out as a big puff of black smoke.

Assuming the BOV isnt leaking under boost, it wont make the car blow smoke continuously when under load, just the big puff after a gearchange.

" black smoke ONCE out the exhaust but not constantly" Im a bit confused as to when it is blowing smoke. A venting BOV will blow black smoke and make it run rich on gearchanges, as the ECU thinks that air coming out the BOV is going through the motor, so it adds the corresponding amount of fuel. When you change gears it fuels the motor up, then when you accelerate again it comes out as a big puff of black smoke.

Assuming the BOV isnt leaking under boost, it wont make the car blow smoke continuously when under load, just the big puff after a gearchange.

OHHH~ i get it now... Well u know i heard it was just a big puff of black smoke when i 'double d clutch' so im assuming when i change gears after revving so high in neutral??? also in stationary ive revved it in neutral but it wasn't so much of a black smoke and it didn't seem like a big puff however there was slightly black smoke coming out as it was revved in neutral to like 6000rpm... So??

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeah well per the video it took 15s for the stock unit to start up....even if I give it a few seconds discount for starting that is at least 12 sec before you get a reverse camera if you are trying to leave a park.  The android unit is way faster, but 2016 for the stock unit is a long time ago in consumer electronics
    • Yea that’s why I said ima test them with multimeter and see the reads.
    • Only at idle. Isn’t a problem when rev it seems.
    • @Haggerty This seems silly to ask, but are you confident in your ability to tune the Haltech?  
    • Next on the to-do list was an oil and filter change. Nothing exciting to add here except the oil filter is in a really stupid place (facing the engine mount/subframe/steering rack). GReddy do a relocation kit which puts it towards the gearbox, I would have preferred towards the front but there's obviously a lot more stuff there. Something I'll have to look at for the next service perhaps. First time using Valvoline oil, although I can't see it being any different to most other brands Nice... The oil filter location... At least the subframe wont rust any time soon I picked up a genuine fuel filter, this is part of the fuel pump assembly inside the fuel tank. Access can be found underneath the rear seat, you'll see this triangular cover Remove the 3x plastic 10mm nuts and lift the cover up, pushing the rubber grommet through The yellow fuel line clips push out in opposite directions, remove these completely. The two moulded fuel lines can now pull upwards to disconnect, along with the wire electrical plug. There's 8x 8mm bolts that secure the black retaining ring. The fuel pump assembly is now ready to lift out. Be mindful of the fuel hose on the side, the hose clamp on mine was catching the hose preventing it from lifting up The fuel pump/filter has an upper and lower section held on by 4 pressure clips. These did take a little bit of force, it sounded like the plastic tabs were going to break but they didn't (don't worry!) The lower section helps mount the fuel pump, there's a circular rubber gasket/grommet/seal thing on the bottom where the sock is. Undo the hose clip on the short fuel hose on the side to disconnect it from the 3 way distribution pipe to be able to lift the upper half away. Don't forget to unplug the fuel pump too! There's a few rubber O rings that will need transferring to the new filter housing, I show these in the video at the bottom of this write up. Reassembly is the reverse Here's a photo of the new filter installed, you'll be able to see where the tabs are more clearing against the yellow OEM plastic Once the assembly is re-installed, I turned the engine over a few times to help build up fuel pressure. I did panic when the car stopped turning over but I could hear the fuel pump making a noise. It eventually started and has been fine since. Found my 'lucky' coin underneath the rear seat too The Youtube video can be seen here: https://www.youtube.com/watch?v=uLJ65pmQt44&t=6s
×
×
  • Create New...