Jump to content
SAU Community

New Rb26 In With N1 Turbos, Running Stock Boost - Feels Like Normal Rb26dett


Recommended Posts

Hey guys, are these r34 n1's suppose to handle more boost than the stock setting, as ive just put in a rb26dett motor to replace my blown one from the r33, and the new engine feels the same - cant tell the different at all....though it is running stock boost right now - im not going to up the boost till my fuel pump and injectors + tune goes in, and until i know the new motor is all OK.

so you've put in a stock RB26 with N1s which are pretty close to stock, and your complaining that it feels stock? N1's are the factory steel wheeled turbos from memory, so yes you can run alot more boost when you get the injectors/tune

Not that I have 34n1 (i have 33 type non bearing n1s, 32 gt-r) but my car feels like a slug on stock boost, a standard car would be faster. But the difference at 1.2 bar is amazing, wait till you get some boost into these turbos, you should make some serious power!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So....to find any R chassis part number, get your VIN (will be something like ER33-xxxxxx for you) and go to: https://www.amayama.com/en/genuine-catalogs/nissan and enter it. From there you have access to a web version of Nissan's part system, FAST. It is a bit tricky to get used to, so maybe have a shot and post up what you think.  You can also search by general model but note in some cases your car might have different options so VIN is safest.  On diagram 211 I got 14075-75T16 for Connector, Water Hose If I search for part 14053‑21U10 that you posted, that is also a water hose but not the one bolted to the plenum and 14075‑04U00 is the fitting where the water hose goes into the block.
    • Yeah now we are talking I much prefer coolers in the front middle because it lessens the chance of a small bump to a corner stopping the whole event. I was thinking the AT cooler can move out of the radiator, delete the AT/engine coolant interwarmer and mount a separate cooler with a thermoswitch somewhere further back as is common in racing, that would be one thing. Beyond that, the engine oil cooler is an obvious one to move to the wheel arch, potentially one on each side, but unused space is an issue. I did have a earlier pic with the bumper off but it doesn't show how busy the corners are: DS is full of the auto driving sensors and PS is totally fully of windscreen washer fluid reservoir But ultimately I was hoping to keep the AC, and the water/air heat exchanger is fundamental so it is not just the radiator that needs to be in front BTW here's airflow to the rad as it ran at the track (one horn is gone now and I'll remove the lights next time):
    • your right the maps for Australia came out in 2017 but are 2010 maps. i got the updated maps SD card put it in and it was the same. Same maps in my Brothers Nissan Patrol. 2020 i think his car is
    • Yeahhhh, the costs have killed me. Spent more than the cost of an engine rebuild and it most mostly servicing and a tune lol.
×
×
  • Create New...